Dyson DC18 Service Manual page 24

service manual
Duct replacement - assemble
81
Lower the inner bucket into the new duct
assembly. Note: ensure the grommets on the
coiled cable and micro swich loom seal against
the openings in the base of the duct.
82
Locate the internal cable into the hole in
the base of the duct assembly.
83
Ensure the grommet on the end of the
internal cable sits flush against the duct. Firmly
press the internal cable into the channel along
the length of the duct assembly.
21
84
Locate the lower duct cover seal into the
base of the duct.
85
Locate the lower duct cover onto the seal.
Refit the four screws highlighted on the cover.
86
Press the cyclone release catch into the
channels on the front of the duct assembly.
Issued 10/06