Siemens SCALANCE W788-1PRO Operating Instructions Manual page 59

To comply with FCC part 15 rules in the United States, the system must be professionally
installed to ensure compliance with the Part 15 certification. It is the responsibility of the
operator and professional installer to ensure that only certified systems are deployed in the
United States. The use of the system in any other combination (such as co-located antennas
transmitting the same information) is expressly forbidden.
Note
In the USA, the "ANT793-8DN" antenna is approved only for wireless mode 802.11a!
Note
The specified approvals apply only when the corresponding mark is printed on the product.
RSS-210 of Industry Canada
"Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that
may cause undesired operation of the device."
"This device has been designed to operate with the antennas listed below*, and having a
maximum gain of 18 dBi. Antennas not included in this list or having a gain greater than 18
dBi are strictly prohibited for use with this device. The required antenna impedance is 50
ohms."
"To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
permitted for successful communication."
"That the device for the band 5150-5250 MHz is only for indoor usage to reduce potential for
harmful interference to co-channel mobile satellite systems."
"Users should also be cautioned to take note that high power radars are allocated as primary
users (meaning they have priority) of 5250-5350 MHz and 5650-5850 MHz and these radars
could cause interference and/or damage to LE-LAN devices."
* For more detailed information on the approved antennas, refer to the section "Technical
specifications".
Note
In Canada, the "ANT793-8DN" antenna is approved only for wireless mode 802.11a!
Note
The specified approvals apply only when the corresponding mark is printed on the product.
SCALANCE W788-xPRO/RR / W74x-1PRO/RR
Operating Instructions, 07/2014, A5E02280448-08
7.1 Approvals for the SCALANCE W788-xPRO/RR and 74x-1PRO/RR
Certification
59