DeWalt DCD708 Original Instructions Manual page 50

EnGLIsH
If the tool does not change speeds, confirm that the
speed selection switch is completely engaged in the
forward or back position.
Mode Selection (Fig. A)
The mode selection collar
correct operating mode depending upon the planned
application.
To select, rotate the collar until the desired symbol
aligns with the arrow.
symbol
1–15 Screwdriving (higher number =
Hammerdrilling (DCD709 only)
Variable Speed Trigger and
Forward/Reverse Control Button
(Fig. A, E)
The drill is turned on and off by pulling and releasing
the variable speed trigger
is depressed, the higher the speed of the drill. Your
tool is equipped with a brake. The chuck will stop as
soon as the trigger switch is fully released.
A forward/reverse control button
rotational direction of the tool and also serves as a lock-
off button.
• To select forward rotation, release the trigger and
depress the forward/reverse control button on the
right side of the tool.
• To select reverse, depress the forward/reverse
control button on the left side of the tool.
nOTE: The centre position of the control button locks
the tool in the off position. When changing the position
of the control button, be sure the trigger is released.
nOTE: Continuous use in variable speed range is
not recommended. It may damage the switch and
should be avoided.
nOTE: The first time the tool is run after changing the
direction of rotation, you may hear a click on start up.
This is normal and does not indicate a problem.
OPERATION
Instructions for Use
4
6
can be used to select the
6
Mode
Drilling
greater torque)
. The farther the trigger
4
determines the
5
WARNING: Always observe the safety instructions and
applicable regulations.
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before
making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Proper Hand Position (Fig. C)
WARNING: To reduce the risk of serious personal
injury, ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle 3 and one hand on the battery pack.
Worklight (Fig. A)
There is a worklight 8 located on the foot of the tool.
The worklight is activated when the trigger switch is
depressed. When the trigger is released, the worklight
will stay illuminated for up to 20 seconds.
nOTE: The worklight is for lighting the immediate work
surface and is not intended to be used as a flashlight.
Performing an Application (Fig. A,
D)
WARNING: To reduce the risk of personal
injury,
ALWAYS ensure workpiece is anchored or clamped
firmly.
WARNING: Always wait until the motor has come to
a complete standstill before changing the direction
of rotation.
Prior to performing work:
• Set the speed selector
• Install the appropriate bit or accessory into the
chuck. Refer to Installing a Bit or Accessory into a
Keyless Chuck.
WARNING:
• Do not use this tool to mix or pump easily
combustible or explosive fluids (benzine, alcohol,
etc.).
• Do not mix or stir flammable liquids labeled
accordingly.
Screwdriving
7 . Refer to Speed Selection.