Advertisement
Quick Links
The OPITEC handicraft packs are not toys in a typical off-the-shelf sense,
but rather additional teaching and learning material for educational pur-
poses. This craft pack may only be constructed by children and ado-
lescents under the guidance and supervision of experienced adults. Not
suitable for children under 36 months. Choking hazard!
Components List
Wooden Strip
Wooden Strip
Steel Spring Clamp
Screw
Ring Screw
Metal Axle
Steering Wheel
Blowpipe
Balloon
1
Rocket Vehicle with
Reverse Propulsion
Please Note:
Quantity
1
1
1
1
4
2
4
1
1
104.966
WARNING !
Balloons are NOT suitable for inflation by children under eight years
old. In certain conditions they can be swallowed. Children under eight
years old can suffocate from not properly inflated or burst balloon pi-
eces. Therefore children should be kept under adult supervision at all
times when inflating them. Store all non inflated balloons out of the
reach of young children.
Remove all burst balloon pieces at once and dispose of them safely.
Keep balloons away from the eyes and always use a pump to inflate
them! It should be noted that balloons are made with a natural rubber
that can in some cases cause allergies. Store the balloons in a cool
place away from sunlight. Keep these instructions and the balloons to-
gether in the original packing until its time to use them.
Size (mm)
200x50x10
50x50x10
14-17
ø3x16
12
ø3x70
ø37
Required Tools:
Pencil
Ruler
Pricking Awl
Wood Glue
Description
Base Plate
Blowpipe Structure
Blowpipe Support
Fixing Steel Spring Clamp
Axle Support
Axle
Wheels
Blowpipe
Propulsion
Phillips
Screwdriver
Part No.
1
2
3
4
5
6
7
8
9
Advertisement
Summary of Contents for Opitec Rocket Vehicle with Reverse Propulsion
- Page 1 Therefore children should be kept under adult supervision at all times when inflating them. Store all non inflated balloons out of the The OPITEC handicraft packs are not toys in a typical off-the-shelf sense, reach of young children. but rather additional teaching and learning material for educational pur- Remove all burst balloon pieces at once and dispose of them safely.
- Page 2 Instructions 104966 Rocket vehicle with reverse propulsion On the base plate (1), mark the position for the axle supports (ring screws 5) according to the dimensions. Then precut with the pricking awl. Insert the axles through the ring screws, as shown, and fix a steering Screw in the ring screws (5) at the marked positions as shown.
- Page 3 Instructions 104966 Rocket vehicle with reverse propulsion Insert the blowpipe (8) centered into the steel spring clamp (3), as Place the balloon (9) on the end of the blowpipe so that it is shown above. stuck. Done! Functioning: Blow up the balloon through the blowpipe. Place the vehicle on the ground and let it go.