Advertisement
Quick Links
The Opitec Range of projects is not intended as play toys for young children. They are teaching
aids for young people learning the skills of craft, design and technology. These projects should
only be undertaken and operated with the guidance of a fully qualified adult. The finished pro-
jects are not suitable to give to children under 3 years old. Some parts can be swallowed. Dan-
Parts List
plywood
grey cardboard
propeller hub
wing nut
washer
cord
solar cell casted
electrical wire
solar motor
lens Phillips-head screw
cylinder head screw
1
Solar Carousel
Please Note!
ger of suffocation!
Quantity
1
1
1
1
1
1
1
1
1
2
1
118.819
Tools Required:
jigsaw
ruler
slot screwdri-
ver
Size (mm)
200x120x5
210x150x1
M4
9/4
2000
500
ø4x20
scissors
wood glue
pencil
superglue
wrench
hot glue gun
craft knife
adhesive tape
Designation
individual parts
carousel top/ seats
motor connection upper part
mounting swivel arm
mounting swivel arm
suspension seats
drive
circuit
drive
mounting solar cell
mounting swivel arm
wire stripper
ø4
drill
Philips
screwdriver
soldering iron
and solder
Part No.
1
2
3
4
5
6
7
8
9
10
11
Advertisement
Summary of Contents for Opitec Solar Carousel
- Page 1 Please Note! The Opitec Range of projects is not intended as play toys for young children. They are teaching aids for young people learning the skills of craft, design and technology. These projects should only be undertaken and operated with the guidance of a fully qualified adult. The finished pro- jects are not suitable to give to children under 3 years old.
- Page 2 Instruction 118819 Solar Carousel ø4 Screw the two parts (1b) to the part (1a) with the screw (11), the washer Transfer the template (page 5) to the plywood 1 and drill through and (5) and the wing nut (4) as illustrated. Glue the two parts (1c) centered saw out all parts (1-1d).
- Page 3 Instruction 118819 Solar Carousel Cut 12 pieces about 160 mm length off the cord (6). Then glue 2 pieces Insert the motor (9) into the hub (3). Glue the hub (3) to the centre in each seat with superglue as shown...
- Page 4 Instruction 118819 Solar Carousel Please note: Thread the cables through the slot Guide the motor cable through the slot in the column. Then solder Fasten the solar cell with screws (10) to the base plate as shown. or twist the cable from the + pole of the solar cell with the red motor cable.
- Page 5 Instruction 118819 Solar Carousel Template Plywood S 1:1...
- Page 6 Instruction 118819 Solar Carousel...
- Page 7 Instruction 118819 Solar Carousel Template Grey Cardboard S 1:1...