Advertisement
Instructions 104966
Rocket vehicle with reverse propulsion
1
On the base plate (1), mark the position for the axle supports (ring screws 5) according to the dimensions. Then precut with the pricking awl.
2
5
Screw in the ring screws (5) at the marked positions as shown.
4
2
Center the wooden strip (2) and glue it onto the base plate (1) flush
with the edge.
2
1
3
7
6
Insert the axles through the ring screws, as shown, and fix a steering
wheel (7) from both sides.
5
4
3
Fasten the steel spring clamp (3) in the middle of the wooden struc-
ture (2) using the screw (4). See picture! Precut the screw hole.
7
6
7
7
Advertisement
