Configuring Am; To Set The Carrier Frequency; To Set The Rf Output Amplitude; To Set The Am Depth And Rate - Agilent Technologies E8247C PSG CW User Manual

Configuring AM

In this example, you will learn how to generate an amplitude-modulated RF carrier.

To Set the Carrier Frequency

Preset
1. Press .
Frequency 1340
2. Press >

To Set the RF Output Amplitude

Amplitude 0 dBm
Press > >

To Set the AM Depth and Rate

AM
1. Press the hardkey.
AM Depth 90
2. Press >
AM Rate 10
3. Press >
The signal generator is now configured to output a 0 dBm, amplitude-modulated carrier at 1340 kHz with
the AM depth set to 90% and the AM rate set to 10 kHz. The shape of the waveform is a sine wave. Notice
that sine is the default selection for the

To Turn on Amplitude Modulation

Follow these remaining steps to output the amplitude-modulated signal.
AM Off On
1. Press the
2. Press the front panel
The AM and RF ON annunciators are now displayed. This indicates that you have enabled amplitude
modulation and the signal is now being transmitted from the RF OUTPUT connector.
Chapter 4
kHz
> .
.
%
> .
kHz
> .
AM Waveform
softkey to On.
RF On Off
key.
softkey, which can be viewed by pressing
Analog Modulation
Configuring AM
(More 1 of 2)
.
79