Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Clarion TTX001
Summary of Contents for Clarion TTX001
- Page 1 TTX001 TV TUNER OWNER’S MANUAL...
-
Page 2: Table Of Contents
INTRODUCTION The Clarion TTX001 is a TV Tuner. It can be integrated into a mobile multimedia system. It has a number of features, including: • Two types of wiring permitted - stand alone or with VMA1131 • Quick tuning to your desired stations •... -
Page 3: Description
DESCRIPTION The Clarion TTX001 TV tuner has a number of exceptional features. For instance, the TTX001 allows two types of wiring: stand alone or with the Clarion VMA1131. It also has preset tuning (for a total of 12 VHF/UHF stations), manual tuning and automatic tuning to permit easy tuning of the desired broadcast stations. -
Page 4: Wiring Precautions
WIRING PRECAUTIONS Read all wiring precautions. If you are not sure of the connections, contact your authorized Clarion dealer. 1. Disconnect the negative (-) lead of the battery before making any power connections. 2. When creating passage holes for the power wires, use grommets to eliminate any sharp edges created during drilling. -
Page 5: Applications
APPLICATIONS The TTX001 can be operated in a number of applications. Find yours below. 1. Place tuner into the channel on the back of the monitor and slide the tab into the slot. Mount tuner with the two machine screws supplied. - Page 6 RCA into the FM100S audio inputs. 7. Mount the switch for the FM100S and run its power wire to the radio location. The power and ground wires of the TTX001, video player, OHM641 and the FM100S can be joined and connected to the radio accessory and ground wires.
- Page 7 Figure 4- TTX001 with OHM641, VDH9600 and FM100S...
- Page 8 Point the TV remote (RC-300) at the OHM641 and press power. You should now see the TV displayed on the monitor and can control the TV tuner functions with its remote. • Turn on the headphones with its power switch to listen to the audio. Figure 5- TTX001 with OHM641 and WH200...
-
Page 9: Remote Control Battery Installation
REMOTE CONTROL BA TTERY INSTALLATION • Insert 2 AAAbatteries into the compartment located on the back of the unit, observing the proper polarity. NOTES: • Each time you change the batteries, you must reprogram the channels. • We suggest you use alkaline batteries; do not use rechargeable batteries. •... -
Page 10: Troubleshooting
TROUBLESHOOTING Before assuming malfunction of the unit, check the following: Problem: No power. Solution: • The fuse may be burned out. Replace the fuse with one of the same rating. • The wiring is incomplete. Check the wire connections and connect them properly. -
Page 11: Product Specs
PRODUCT SPECS Power Source Voltage: Power Consumption: Operation Temperature: NOTES DC 11-15V 1.5Amax. (1.5Aor less) 30 - 113 degrees F... - Page 12 661 W. Redondo Beach Blvd. Gardena, CA 90247 1-800-GO-CLARION www.clarion-usa.com TTX001-10 Rev.2 (03/00)
Need help?
Do you have a question about the TTX001 and is the answer not in the manual?
Questions and answers