Installing / Removing Light Fixtures; Replacing / Removing Lamps - Masalta ML42 Instruction Manual

MAINTENANCE

3.2 Installing / Removing Light Fixtures

Prerequisite
Circuit breakers are turned OFF
Engine is shut down
WARNING
Electric shock hazard.
Turn off all light circuit breakers and shut down engine before
disconnecting light fixtures or changing lamps.
WARNING
Burn hazard. Lamps and fixtures become extremely hot in use.
Allow lamps and fixtures to cool 10–15 minutes before handling.
NOTICE: Only a trained technician should be allowed to install and remove fixture
wiring.

3.3 Replacing / Removing Lamps

Prerequisites
Engine shut down
Light circuit breakers turned OFF
Lamps and fixtures cool to the touch
Eye protection and gloves
WARNING
Burn hazard. Lamps become extremely hot in use.
Allow lamps and fixtures to cool 10–15 minutes before handling.
WARNING
Personal injury hazard. Ultraviolet radiation from the lamps can
cause serious skin and eye irritation.
Use only undamaged lamps.
Use the lamps only with undamaged original equipment lenses
and fixtures.
WARNING
Explosion hazard. Grease or oil residue on the lamp can cause
the outer jacket to burst or shatter. Hot flying glass particles can
cause personal injury, property damage,burns, or fire.
Do not operate the lights with a lens that is cracked, damaged, or
missing.
Do not scratch the lamp or subject the lamp to excess pressure.
Wear eye protection and gloves when removing or replacing
lamps.
21