Advertisement
ETC Reference Guide
F-Drive R12 and W1 Wiring
ArcSystem Pro One-Cell Luminaires with an FD-BBOX-4M
The most convenient way to connect ArcSystem Pro One-Cell luminaires to an
F-Drive R12 CC-150 Card or W1 CC Driver is with an F-Drive FD-BBOX-4M. FD-BBOX-4M takes a
single four-channel RJ45 output from an F-Drive R12 CC-150 Card or W1 CC Driver and provides four
separated Molex outputs for ArcSystem Pro One-Cell luminaires. Refer to the F-Drive B-Box4
Installation Guide and visit the F-Drive System Design Tool at
Controls/LED-Drivers/F-Drive/F-Drive-System-Design-Tool.aspx.
Note:
local jurisdiction requirements.
FDW1CCD (-CE)
SENSE
MAINTAIN
Driver can be W1
or R12
FDR12FD
Description
CC-150 Card installed in
one card slot of an
A
FDR12FD
W1 CC Driver
B
Category-type cable
Use cable attached to
C
ArcSystem Pro luminaire
ArcSystem Pro One-Cell
D
luminaire
*See
Constant Current Driver Configuration for ArcSystem Pro One-Cell Luminaires on the previous page
Note: The illustration is not drawn to scale.
F-Drive R12 and W1 Wiring
If used within an Emergency Lighting Circuit, follow NEC marking requirements or
A
DMX
DMX
1 2 3 4
IN
THRU
FD-BBOX-4M
B
B
A
Notes
The CC-150 Card and W1 CC Driver output constant current, adjustable from 200–700 mA.*
The cable from the RJ45 output of the driver to the input of the FD-BBOX-4M. You must use
2
0.25 mm
(23 AWG) or larger conductors in Category-type cable. Not all Cat5 or Cat6 cables meet
this requirement.
Extension cables are available. See the datasheet for ArcSystem Pro One-Cell luminaires at
etcconnect.com/arcsystem.
Pro One-Cell (ARCP1), Pro One-Cell Small (ARCP1S), or Pro One-Cell Micro* (ARCP1M); White or
Fade to Warm.
etcconnect.com/Products/Power-
C
C
C
Ch 3
Ch 2
Ch 1
D
D
D
Page 9 of 17
C
Ch 4
D
.
ETC
Advertisement
