Sea Breeze SMZC9H4ZIGX User Manual page 9

SLEEP – Press this button, can select Sleep modes from Sleep 1
● Sleep 1 - In the COOL mode adjust the set-point temperature to a comfortable setting, and
then press the SLEEP button. After 1 hour, the set-point will increase by 1.8 ºF (1 ºC). After 2 hours
have passed temperature is increased by 3.6 ºF (2 ºC). Temperature will never increase more than
3.6 ºF (2 ºC) from set-point or beyond 86 ºF (30 ºC). The temperature will stay at this setting until
the unit is turned off or the SLEEP function is disabled.
In the HEAT mode adjust the set-point temperature to a comfortable setting, and then press the
SLEEP button. After 1 hour the set-point will decrease by 1.8 ºF (1 ºC). After 2 hours have passed
temperature is decreased by 3.6 ºF (2 ºC). Temperature will never decrease more than 3.6 ºF (2 ºC)
from set point or below 61 ºF (16 ºC). The temperature will stay at this setting until the unit is turned
off or the SLEEP function is disabled.
The SLEEP mode does not work in the FAN or AUTO modes and is deactivated when the unit is
turned off or power is lost. On power up, the SLEEP mode must be turned on again if needed.
Press the SLEEP mode button to toggle SLEEP mode off and return to normal operation.
● Sleep 2 - The air conditioner will operate according to the presetted sleep temperature curve.
● Sleep 3 - Program your own sleep operation.
1) Under this mode, hold "TURBO" button for several seconds until "1 hour" displays on the timer
position to active the user's setting of sleep mode. At this time, the temperature is blinking with the
last setting of sleep. (It displays the factory presetted setting temperature for the first entering)
2) Adjust "+" or "-" button to change the setting temperature, and then press Turbo button to save.
3) After the temperature was set, "1 hour" displays on the timer position will be changed to 2 hour
automatically, and then repeat the step 2) to set temperature of second hour.
4) Repeat the above steps 2) and 3) for two more setting of "3 hour" and "8 hour".
When all settings are completed, the original timer display and temperature display will be resumed.
● During Sleep 3 , the factory presetted sleep program (Sleep 2) or your own sleep program can
be inquired by press the "Turbo" button only.
Note: In above setting and enguiry procedure, it will quit the status automatically and resume the
original display if on button pressed in 10 seconds or any of "ON/OFF", "MODE", "TIMER" or
"SLEEP" button pressed.
TEMP – Press this button, the icons will be cycled between
displays set temperature always.
set temperature. displays set temperature.
QUIET – Press this button to active the Quiet function which decrease the indoor fan speed to
very low (lower than Low speed). The "AUTO" icon comes out just above the
function can be disabled by pressing this button again or pressing FAN button. QUIET function is
enabled in FAN and DRY mode.
CLOCK – Press the CLOCK button, the clock ICON will start to blink. It will only blink for 5
seconds. While blinking press and hold down the + or - keys to adjust the 24H time of day clock to
the correct time. You must immediately press the CLOCK button to set the time. If the CLOCK
button is not pressed within 5 seconds, the clock time will revert back to the original setting and
clock will have to be set again.
T-ON / T-OFF – This button was divided into two parts. The left one which shows "T-ON" is for
Timer On, and the right one shows "T-OFF" is for Timer OFF.
Press T-ON (left side) to initiate the timer on. After pressing T-ON once,
"ON" blinks. "00:00" is shown on display for ON time setting. Press "+" or "-" button to adjust the
time value in 5 seconds. Each press will increase or decrease one minute. Holding down either "+"
or "-" button to change the time every ten minutes. Press the T-ON again in 5 seconds to confirm
the setting and quit.
950-0205revC
,
displays room temperature for a few seconds then display
- 9 -
, Sleep 2 or, Sleep 3
and in the remote display.
icon as well. Quiet
icon extinguishes and
July 22, 2015
.