Programming Your Remote - Cisco ISB7050 User Manual

Programming Your Remote Control
Our professionally trained Installation Technicians will program your remote
control(s) at the time of your initial install. If you have purchased a new TV and
need to reprogram the remote, you can either contact our Technical Assistance
Center at 715-421-6085 for help or follow these instructions below.
Automatic Programming
• Turn on the TV.
• Press and hold the TV Mode button first, and then press and hold the OK
key at the same time for about 3-5 seconds. When released, all mode keys
should blink twice.
• Press 9 2 2, TV Mode button should blink 3 times.
• Point the remote at the TV and press PLAY, press and release until the TV
turns off.
• Press the Enter/Zoom key when the TV turns off, the TV key will flash 3 times.
• If you miss the code, you must start over.
• Alternatively, instead of repeatedly pressing the play button over and over,
you can just hold it down and it will cycle through the codes. Once the TV
turns off, just let go of the play button. If you let go as soon as the TV goes
off, you should be on the code.
Manual Programing
• Turn on the TV.
• Press and hold the TV Mode button first, and then press and hold the OK
button at the same time for about 3-5 seconds. When released, all mode
keys should blink twice.
• Enter the 4 digit setup code for your TV (codes can be found at:
www.solarus.net/wp-content/uploads/2014/11/Remote-Control-User-Manual.pdf).
The TV key will blink 3 times.
• Press POWER, the TV turns off if it was the correct code.
• Repeat previous steps if the TV does not turn off.
7