Setting The Gain; Setting The Crossover; Setting The Subwoofer Bass Boost - Clarion APX290M Operating & Installation Manual

Power system amplifier
Hide thumbs Also See for APX290M:
Table of Contents

Advertisement

Available languages

Available languages

APX280M APX490M manual.qxd
APX290M/APX490M Power System Amplifier

SETTING THE GAIN

After completing the installation, follow these steps to set the Gain Control and
then perform the Final System Checks.
1. Turn the Gain Control all the way counter-clockwise.
2. Turn the ON/OFF Switch on the source units to the ON position. Set all Tone or
Equalization Controls to "flat" positions and turn Loudness off.
3. Play a CD, set the Volume Control at 75% of full level.
NOTE: If the system uses an equalizer, set its frequency controls to "flat"
positions.
4. Slowly increase the Gain Control. Stop when you hear a slight distortion of audio.

SETTING THE CROSSOVER

The Clarion APX290M features a fully adjustable crossover, the APX490M features
fully adjustable front and rear crossovers. To set the crossover, follow these steps.
1. Using the X-Over Mode Switch, select the desired mode: LP for Low Pass, HP
for High Pass or OFF for Full Range.
2. Using the Freq (Hz) Selection Control, select the desired frequency. If the
desired frequency exceeds the range of the Freq (Hz) Selection Control, press
the Crossover Frequency Multiplier Switch to increase the value by a multiplier
of 10.
• For example, 55Hz x 10 = 550Hz or 550Hz x 10 = 5.5kHz.
3. Repeat steps 1 and 2 for both the front and rear crossovers on the APX490M.

SETTING THE SUBWOOFER BASS BOOST

1. Initially set the Bass Boost control to its full left position (i.e. 0dB).
2. Listen to a variety of music styles (e.g. Rock, Rap, etc.) and slowly increase
the Bass Boost control until a noticeable increase in low bass response is
perceived.
3. Slowly adjust the Bass Boost control (up or down) to realize the best bass
response.
CAUTION: If you hear a "pop" (due to speaker over-excursion), lower the
Bass Boost to prevent speaker damage. If the system sounds muddy and
distorted (due to amplifier clipping), lower Bass Boost to avoid shutdown from
overheating.
15
2/6/2008
11:38 AM
Page 16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Apx490m

Table of Contents