Advertisement
IMPORTANT: A custom wiring harness (separately purchased) which is suitable for your car is recommended for connection between the unit and your car.
• Consult your JVC car audio dealer or a company supplying kits for details.
Reset the unit.
Antenna input
Front speaker (left)
Front speaker (right)
Rear speaker (left)
Rear speaker (right)
Connecting the external components in series
When connecting the external components, refer also to the manuals supplied for the components and adapter.
To disconnect...
You can connect the following components through the various JVC adapters to the expansion port.
• Connection cords may need to be purchased separately.
Bluetooth device
Portable audio player with line output jacks
Portable audio player with 3.5 mm stereo mini jack
1
*
Not supplied for this unit.
2
*
Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint.
3
*
Before checking the operation of this unit prior to installation, this lead must be connected; otherwise, the power cannot be turned on.
4
*
To use these components, set the external input setting correctly (see page 25 of the INSTRUCTIONS).
ELECTRICAL CONNECTIONS
Connecting the external amplifier or subwoofer
Signal cord *
Signal cord *
Steering wheel remote input
White
White (black stripe)
Gray
Gray (black stripe)
Green
Green (black stripe)
Purple
Purple (black stripe)
Expansion port of the unit
A KS-BTA200
B*
4
KS-U57 / KS-U58
Component
Remote lead
1
JVC Amplifier
Remote lead
1
JVC Amplifier
Rear ground terminal
15 A fuse
Expansion port
D Power cord
Black
To the metallic body or chassis of the car
3
Yellow *
To a live terminal (constant 12 V)
Red
To an accessory terminal
Blue
To the automatic antenna if any (250 mA max.)
Blue (white stripe)
Orange with white stripe
Caution:
Before connecting the external components, make sure that the unit is turned off.
Bluetooth adapter
Line input adapter
AUX input adapter
2
1
Y-connector *
To the blue (white stripe) lead of
the unit
Rear speakers or subwoofer (Make the <L/O MODE> setting accordingly,
see page 24 of the INSTRUCTIONS.)
1
Y-connector *
To the blue (white stripe) lead of
the unit
Front speakers
Ignition switch
Fuse block
To the remote lead of other equipment (200 mA max.)
To car light control switch
Adapter
Model name
KS-BTA200
KS-U57
KS-U58
Advertisement
