Zanussi ZWS624B4S User Manual page 29

2. On the edge of a sink - Fasten the guide to the
water tap or to the wall.
Make sure that the plastic guide
cannot move when the appliance
drains and the drain hose end is not
immersed in the water. There may be a
return of dirty water into the appliance.
3. If the end of the drain hose looks like this (see
the picture), you can push it directly into the stand
pipe.
4. To a stand pipe with vent-hole - Insert the drain
hose directly into a drain pipe. Refer to the
illustration.
The end of the drain hose must always
be ventilated , i.e. the inner diameter of
the drain pipe (min. 38 mm - min. 1.5")
must be larger than the external
diameter of the drain hose.
5.Without the plastic hose guide, to a sink spigot-
Put the drain hose in the spigot and tighten it with a
clamp. Refer to the illustration.
sure that the drain hose makes a loop to prevent
particles going into the appliance from the sink.
6. Position the hose directly to a built-in drain pipe
in the room wall and tighten it with a clamp.
ELECTRICAL CONNECTION
At the end of installation you can connect the mains
plug to the mains socket.
The rating plate and the 'Technical Data' chapter
indicate the necessary electrical ratings. Make sure
that they are compatible with the mains power
supply.
Check that your domestic electrical installation can
take the maximum load required, also taking into
account any other appliances in use.
Connect the appliance to an earthed socket.
The power supply cable must be easily accessible
after installing the appliance.
Make
29