Environment; Physical Characteristics; Emc; Safety - Advantech AIIS-1240 User Manual

1.3.13

Environment


Operating Temperature: 0 ~ 45 º C (32 ~ 113 º F)*

Non-operating Temperature: -40 ~ 70 º C (-40 ~ 158 º F)

Operating Humidity: 10 ~ 95% @ 40 º C, non-condensing

Non-operating Humidity: 10 ~ 95% @ 60 º C, non-condensing
* Depends on CPU, i7 CPU supports 0 ~ 40 º C.
1.3.14

Physical Characteristics


Dimension (WxHxD): 232 x 70 x 175 mm

Weight: 2.5Kg
1.3.15

EMC

CE, FCC, CCC, BSMI
1.3.16

Safety

UL, CB, CCC, BSMI
1.4

Jumper Settings

1.4.1

How to Set Jumpers

You can configure your motherboard to match the needs of your application by set-
ting the jumpers. A jumper is a metal bridge that closes an electrical circuit. It consists
of two metal pins and a small metal clip (often protected by a plastic cover) that slides
over the pins to connect them. To "close" (or turn ON) a jumper, you connect the pins
with the clip. To "open" (or turn OFF) a jumper, you remove the clip. Sometimes a
jumper consists of a set of three pins, labeled 1, 2 and 3. In this case you connect
either pins 1 and 2, or 2 and 3. A pair of needle-nose pliers may be useful when set-
ting jumpers.
1.4.2

BIOS CMOS (JCMOS1)

AIIS-1240 CPU card contains a jumper that can erase BIOS CMOS data and reset
the system BIOS information. Normally this jumper should be set with pins 1-2
closed. If you want to reset those data, set JCMOS1 to 2-3 closed for just a few sec-
onds, and then move the jumper back to 1-2 closed. This procedure will reset the
CMOS to its last status or default setting.
Table 1.1: Clear BIOS CMOS (JCMOS1)
Function
*Keep BIOS CMOS data
Clear BIOS CMOS data
*default setting
AIIS-1240 User Manual
Jumper Setting
1 2 3
1-2 closed
1 2 3
2-3 closed
4