Error Display - Marantz M-CR612 Service Manual

1-7-3. Heat run Chucking mode
Select the "H.R.Chucking" using the "CURSOR f / d " button, then press the "ENTER" or " 1 / 3 " button
to confirm.
• This sets the heat run repetition count to 0.
• Repeatedly performs the following operations.
Repeatedly performs "TOC Load", then "Search for first track of the disc", "Open tray" and "Close
tray" followed by "TOC Load", → •••etc.
An increment is added to the heat run count when the tray is opened.
• Press the "CURSOR d " button during heat run operations to display the current heat run repetition
count for 5 seconds.
Returns once again to heat run mode display after 5 seconds.
xxxx: Count display
• Displays normal playback unless displaying the heat run count

1-7-4. Error display

If an error occurs, operations stop and the error display is displayed.
Operation button (only for this unit)
• "CURSOR f / d " : Item selection
Heat run Error code table
• E1-00: Disc cannot be detected.
• E1-01: Tracking offset adjustment not possible.
• E1-02: Focus offset adjustment not possible.
• E2-00: Focus servo dropped during playback.
• E2-01: Focus servo dropped during searching.
• E2-03: Focus servo dropped during TOC reading.
• E2-05: Focus servo dropped while pausing.
• E2-10: Subcode became unreadable during playback.
• E2-11: Subcode became unreadable during searching.
• E2-12: Subcode became unreadable during TOC reading.
• E2-14: Subcode cannot be read while pausing.
• E2-15: Subcode cannot be read during manual search.
• E3-00: TOC could not be read within the specified time.
• E3-01: PVD/SVD analysis was not be completed within the specified time.
• E4-04: Search time out (The search was not completed within the specified time).
• E4-05: Decoder bus error (Error in communications with CD decoder).
• E5-00: Inner switch is not on.
• E6-00: Inner switch is not off.
• E8-00: Tray is not opened by the specified time.
• E8-01: Tray is not closed by the specified time.
• E9-00: CD Microprocessor error.
• E9-01: Error other than above.
• Error code display
• Repetition count when an error occurs
• CD playback position when an error occurs (For chucking mode, displays "00Tr 00:00")
63