What's Included; Setting Up The Player; Connecting The Unit To A Tv; Connecting External Audio - Iluv i1255 Instruction Manual

GETTING STARTED

What's Included

1. Main Unit
2. Remote Control (Battery Included)
3. AV Cable
4. iPod Dock Adapters
1.
2. 3.
OPEN/
CLOSE STANDBY
SUBTITLE
1 2 3
LANGUAGE
4 5 6
TITLE
7 8 9
GOTO
ANGLE
10+ 0
ZOOM SLOW VOLUME
PAUSE PLAY STOP
MENU SETUP
PAGE PAGE
DOWN UP
ENTER
iPod
MODE iPod/DVD
REV FWD PREV NEXT
A-B REPEAT MUTE RETURN
VIDEO
PROG P/N MODE DISPLAY
i1255
7 | iLuv
5. Instruction Manual
6. Warranty Card
7. QSG (Quick Start Guide)
4.
GETTING STARTED

Setting up the Player

It is recommended that you keep the unit unplugged and disconnected from the wall unit while
connecting the unit.

Connecting the Unit to a TV

• Composite Video (iPod and DVD) – Connect the video cable from the Video Out jack
on the back of the player to the Video In jack on your television set.
• S-Video (iPod and DVD) – For better video quality, connect the player to your television set
using an S-Video cable (not included). Connect the cable from the S-Video Out jack on the
back of the player to the S-Video In jack on the television set.
• Y, Pb, Pr (DVD only) – Use a Component cable (not included) to connect the unit to a
television set. Set the [Video] to Interlace YUV. If the television supports Progressive Scan,
set the [Video] to P-Scan Y, Pb, Pr

Connecting External Audio

The back panel of the iPod/DVD player provides:
COAXIAL Out: Connects to an external audio decoder.
Note on iPod connections:
• Video connection: Your iPod does not support component (Y, Pb, Pr) video output,
so always connect to composite video or S-Video for iPod play.
• Audio connection: Your iPod does not support 5.1 channel audio output and digital
audio output, so always connect to audio FR, FL channels for iPod play.
Before plugging the power cord into the AC outlet, check to make sure all of the connections have
been properly completed. When they have been, carefully plug power cord into outlet. Press the
POWER switch on the rear side to turn on the unit, the power indicator will light up. If unit is in standby
state, press the POWER button on the front panel to power the unit. The display panel will light.
When the unit is initially powered, a brief surge of electricity may cause interference with other
electronic equipment on the same circuit. If this occurs, connect the unit to an outlet on a different
circuit.
i1255 | V10M10_IM_EN_01223008 iLuv | 8