Table of Contents
Advertisement
GETTING STARTED
What's Included
1. Main Unit
2. Remote Control (Battery Included)
3. AV Cable
4. iPod Dock Adapters
1.
3.
Connecting the Speakers
• The i1277 speaker system has a 2.0/5.1CH input selection
switch on rear panel.
• When playing 2.0 channel content, like your iPod, CD, MP3,
VCD and 2.0 channel DVD movies, set this switch to 2.0CH
position, otherwise the subwoofer will not sound.
• When play 5.1 channel DVD movies, set this switch to 5.1CH
position for surround audio effect.
• When set this switch on "2.0CH" position, the SL and SR speaker
CEN, SL and SR speakers
no sound.
7 | iLuv
5. Instruction Manual
6. Warranty Card
7. QSG (Quick Start Guide)
OPEN/
CLOSE
1
2
2.
4
5
7
8
10+
0
REV
FWD
PAUSE
PLAY
MENU/BACK
PAGE
UP
ENTER
iPod
MODE
4.
ZOOM
SLOW
A-B
REPEAT
PROG
P/N
DVD
DVD & iPod
i1277
GETTING STARTED
Setting up the Player
It is recommended that you keep the unit unplugged and disconnected from the wall unit while
connecting the unit.
Connecting the Unit to a TV
• Composite Video (iPod and DVD) – Connect the video cable from the Video Out jack
on the back of the player to the Video In jack on your television set.
STANDBY
SUBTITLE
• S-Video (iPod and DVD) – For better video quality, connect the player to your television set
3
LANGUAGE
6
using an S-Video cable (not included). Connect the cable from the S-Video Out jack on the
TITLE
9
GOTO
ANGLE
back of the player to the S-Video In jack on the television set.
PREV
NEXT
STOP
• Y, Pb, Pr (DVD only) – Use a Component cable (not included) to connect the unit to a
iPod/DVD
PAGE
DOWN
television set. Set the [Video] to Interlace YUV. If the television supports Progressive Scan,
SETUP
set the [Video] to P-Scan Y, Pb, Pr
VOLUME
MUTE
RETURN
VIDEO
MODE
DISPLAY
Connecting External Audio
iPod
The back panel of the iPod/DVD player provides:
COAXIAL Out: Connects to an external audio decoder.
Note on iPod connections:
• Video connection: Your iPod does not support component (Y, Pb, Pr) video output,
so always connect to composite video or S-Video for iPod play.
• Audio connection: Your iPod does not support 5.1 channel audio output and digital
audio output, so always connect to audio FR, FL channels for iPod play.
Before plugging the power cord into the AC outlet, check to make sure all of the connections have
been properly completed. When they have been, carefully plug power cord into outlet. Press the
POWER switch on the rear side to turn on the unit, the power indicator will light up. If unit is in standby
state, press the POWER button on the front panel to power the unit. The display panel will light.
When the unit is initially powered, a brief surge of electricity may cause interference with other
electronic equipment on the same circuit. If this occurs, connect the unit to an outlet on a different
circuit.
i1277 | V10M10_IM_EN_01223008
outlet
iLuv | 8
Advertisement
Table of Contents
