Advertisement
HARDWARE CONTENTS (shown actual size)
AA
Wire
Connector
Qty. 3
SAFETY INFORMATION
READ AND SAVE THESE INSTRUCTIONS.
DANGER
• For your protection and safety, carefully read and understand the information provided
manual completely before attempting to assemble, install or operate this product. Failure to do so
could lead to electrical shock, fire or other injuries that could be hazardous or even fatal.
•
If using this light fixture in a WET location, this light fixture must be connected to a supply circuit
that is protected by a Ground Fault Circuit Interrupter (GFCI) to reduce the risk of personal injury,
electrical shock or death.
•
DO NOT connect this fixture to an electrical system that does not provide a means for equipment
grounding. Never use a fixture in a two-wire system that is not grounded. Installing a fixture into an
electrical system not having a proper grounding means could cause metal parts of the fixture to
carry electrical currents if any of the fixture wires, wire connections or splices were to become
broken, cut or loose during the mounting or normal operation of the fixture. Under this condition,
anyone coming in contact with the fixture would be subject to electrical shock, which could cause
serious injury or death.
•
DO NOT connect the bare or green insulation fixture ground wire to the black (HOT)
current-carrying wire or the white (NEUTRAL) house wire. Connection of the bare or green fixture
ground wire to the black or white house wires may cause metal parts of the fixture to carry electrical
currents. Under this condition anyone coming in contact with the fixture will receive electrical shock,
which could cause serious injury or death.
•
DO NOT damage or cut the wire insulation (covering) during installation of fixture. DO NOT permit
wires to contact any surface having a sharp edge. To do so may damage or cut the wire insulation,
which could cause serious injury or death from electrical shock.
WARNING
•
All electrical connections must be in agreement with local codes and ordinances, the National
Electric Code (NEC) and ANSI/NFPA 70-1999. Contact your municipal building department to learn
about your local codes, permits and/or inspections.
have supply wire rated for 140 ° F. Consult a qualified electrician before installation.
BB
Machine
Screw
Qty. 2
Risk of
fire – most dwellings built before 1985
3
in this
Advertisement
