Voltage And Waveform Chart - Panasonic DMR-E100HP Service Manual

INITIAL/LOGO
X X X' TAL
XALE X ADDRESS LATCH ENABLE
XAREQ X AUDIO DATA REQUEST
XCDROM X CD ROM CHIP SELECT
XCS X CHIP SELECT
XCSYNC X COMPOSITE SYNC
XDS X DATA STROBE
XHSYNCO X HORIZONTAL SYNC OUTPUT
XHINT XH INTERRUPTREQUEST
XI X' TAL OSCILLATOR INPUT
XINT X INTERRUPT
XMW X MEMORY WRITE ENABLE
XO X' TAL OSCILLATOR OUTPUT
XRE X READ ENABLE
XSRMCE X SRAM CHIP ENABLE
XSRMOE X SRAM OUTPUT ENABLE
XSRMWE X SRAM WRITE ENABLE
XVCS X V-DEC CHIPSELECT
XVDS X V-DEC CONTROL BUS
STROBE
XVSYNCO
X VERTICAL SYNC OUTPUT

12. Voltage and Waveform Chart

Note)
- Indicated voltage values are the standard values for the unit
measured by the DC electronic circuit tester (high-impedance) with
the chassis taken as standard.
Therefore, there may exist some errors in the voltage values,
depending on the internal impedance of the DC circuit tester.
12.1. Power Supply P.C.B.
12.2. Main P.C.B.
12.3. Front (R) P.C.B.
12.4. PS9001, PS9002, PS9003 Connectors
12.5. PP9701, PP9702 Waveform
ABBREVIATIONS
52