Moons' Applied Motion Products STR2 Quick Start Manual

S S T T R R 2 2 Q Q u u i i c c k k S S e e t t u u p p G G u u i i d d e e
To begin, make sure you have the following equipment:
▪ A compatible stepper motor.
▪ A small flat blade screwdriver for tightening the connectors (included).
▪ A suitable DC power supply. AMP recommends the PS50A24, PS150A24 or PS320A48 available from Applied Motion.
W i i r r i i n n g g t t h h e e D D r r i i v v e e W
S S t t e e p p 1 1 - - W W i i r r i i n n g g t t h h e e D D C C s s u u p p p p l l y y
a. Wire the drive to the DC power source.
(do not apply power until all connections to the drive have been made)
Note, the STR2 accepts DC voltages from 12-48V.
b. Ensure a proper earth ground connection by using the screw
on the left side of the chassis.
*See the STR2 Hardware Manual for more information about power supply
and fuse selection.
S S t t e e p p 2 2 - - W W i i r r i i n n g g t t h h e e m m o o t t o o r r
Connect the drive to the motor. Four lead motors can be connected in only one way, as shown in Figure 1.
Eight lead motors can be connected in Series or Parallel, as shown in Figures 2 and 3.
If using a non-Applied Motion Products motor, please refer to your motor specs for wiring information.
Red
4
A+
lead
motor
A–
Blu
e
Yellow
B+
Figure 1 - 4-lead Connection
A+
Brow
n
Orang
e
A–
Whit
e
B–
Figure 2 - 8-lead Parallel Connection
White
8
lead
motor
Green
Re
Blac
d
k
Blu
Yello
B+
e
B–
w
White
A+
8
Orang
e lead
Brow
motor
n
A–
Gree
n
Red
Blu
B+
e
Yellow
B–
Figure 3 - 8-lead Series Connection
920-0113 RevD
Blac
k