Advertisement
Deleting relay 1 (Lock output) user codes:
Deleting an individual user code;
Type in - Master Code + Master Code (chime tone) + * + 50 + two digit user number (chime tone) + #
Deleting all user codes; (User 01 defaults to 3333)
Type in - Master Code + Master Code (chime tone) + * + 50 + 00 (chime tone) + #
Setup type or pulse length of relay 1 (Lock output): (Default = 1 sec.)
Set for Latch mode;
Type in - Master Code + Master Code (chime tone) + * + 20 + 00 (chime tone) + #
Set for pulse mode and set pulse length;
Type in - Master Code + Master Code (chime tone) + * + 20 + 01 for 1 sec.......99 for 99sec (chime tone) + #
Setup type or pulse length of relay 2 (Aux output): (Default = Latch mode)
Set for Latch mode;
Type in - Master Code + Master Code (chime tone) + * + 58 + 000 (chime tone) + #
Set for pulse mode and set pulse length;
Type in - Master Code + Master Code (chime tone) + * + 58 + 001 for 1 sec.......999 for 999sec (chime tone) + #
Enable the incorrect code attempt lock out (Anti-hacking) feature: (Default = Disabled)
Keypad disables keystrokes for 30 sec. after 5 incorrect code entries or if 20 consecutive incorrect keystrokes have been
entered. NB! Typing # between keystrokes restarts the incorrect keystroke counter.
Type in - Master Code + Master Code (chime tone) + * + 51 (chime tone) + #
Repeat this to de-activate again.
Enabale the Bypass code function: (Default = Disabled)
When the Bypass code is entered, Relay1/Lock output latches on until the bypass code is re-entered or when the FRX
push-button is used.
Enable the bypass code function:
Type in - Master Code + Master Code (chime tone) + * + 52 + 1 (chime tone) + #
Disable the bypass code function:
Type in - Master Code + Master Code (chime tone) + * + 52 + 0 (chime tone) + #
Setup bypass code: (Default = None)
Type in - Master Code + Master Code (chime tone) + * + 54 + New unique bypass code (chime tone) + #
NEVER USE WITH SOLENOID TYPE STRIKERS or LOCKS!
Page 5
Advertisement
