Advertisement
Master code:
• The master code is only used to access programming mode. (Default master code = 1234)
• The master code can be 4 to 8 digits in length.
• The number of digits used for the master code will determine the length of all user codes (Lock, Aux and bypass users)
i.e. the default master code is 1234. Therefore all user codes will be 4 digits long unless the master code is changed.
• If the master code length is changed after user codes have already been programmed, the following will
occur.
• Master code shortened – the last digits of the user code will be dropped making the user codes the same length as
the master code.
I.e. the old master code was 123456 and user 01 was 987654.
New master is 1234. User 01 becomes 9876.
• Master code length increased – zeros will be added to the end of all user codes so that the user codes are equal in
length to the master code.
I.e. old master code was 1234 and user 01 was 9876
New master code = 123456. User 01 becomes 987600
• Keep a record of all codes and never attempt to program a duplicate of another code already in the keypad.
I.e. user 01 code cannot be the same as the master code.
Other points to note before programming:
• You cannot enter programming mode if one of the relays is active.
• You cannot enter programming mode if the tamper switch is active. Close up the keypad housing first or bypass the
tamper switch monitoring using the dip-switch.
• To exit programming, at any stage, press the # key.
Setup a new master code: (Default = 1234)
Type in - Current Master Code + Current Master Code
I.e. To change the master code to 4321:
Type in - 1234 1234 * 00 4321 #
Setting up users 1 to 19 codes for relay 1 (Lock output): (User 1 default = 3333)
Type in - Master Code + Master Code (chime tone) + * + two digit user number + New User Code (chime tone)
I.e. To setup a single user code (example user 01 to 8282): - 1234 1234 * 01 8282 #
I.e. To setup multiple user codes: - 1234 1234 * 01 8282 * 02 2222 * 03 3333........#
Setup code to activate the relay 2 (Aux output): (Default = 9999)
NB! When programming a new code for the Auxiliary relay, the new code replaces the old code, with no need to erase
the old code.
Type in - Master Code + Master Code (chime tone) + * + 40 + New Auxiliary Code (chime tone) + #
I.e. To setup Aux relay code to 2222:- 1234 1234 * 40 2222 #
+ * + 00 + New 4 to 8 digit Master Code + # (chime tone)
(chime tone)
Page 4
Advertisement
