Related Manuals for Pentair MYERS MSP33V10BP-R
Summary of Contents for Pentair MYERS MSP33V10BP-R
- Page 1 MYERS PREPLUMBED SUMP PUMP SYSTEM MSP33V10BP-R INSTALLATION AND OPERATION MANUAL pentair.com ©2021. All Rights Reserved.
-
Page 2: Table Of Contents
TABLE OF CONTENTS Safety Information ....................................3 Installation ........................................ 4 Operation ........................................5 Maintenance, Performance & Specifications ............................6 Parts List ........................................7 Troubleshooting ....................................... 8 Warranty ........................................11 MY1001-R (11-15-21) -
Page 3: Safety Information
SAFETY INFORMATION SAVE THESE INSTRUCTIONS: This manual contains important Do not touch an operating motor. Modern motors can operate at high temperatures. Do not handle pump or pump motor with wet instructions that should be followed during installation, hands or when standing on wet or damp surface, or in water. operation, and maintenance of the product. -
Page 4: Installation
INSTALLATION DESCRIPTION Risk of electrical shock and fire. Be sure that This Myers Sump Pump System is ideal for basement and power supply information (Voltage/ Hertz/Phase) in this manual cellar installations. It includes a submersible sump pump and matches incoming power supply exactly. Install pump according a corrosion-resistant sump basin and lid. -
Page 5: Operation
INSTALLATION/OPERATION 11. Install the 1-1/2" check valve (supplied) in the discharge OPERATION pipe. Make certain the flow indicating arrow points away The shaft seal depends on water for lubrication and cooling. Do from the pump. This check valve will keep the water from not operate the pump unless it is submerged in water as the running back into the basin when the pump is not running. -
Page 6: Maintenance, Performance & Specifications
MAINTENANCE, PERFORMANCE, & SPECIFICATIONS MAINTENANCE DO NOT attempt to open the pump further than removing the bottom plate. The pump should only be serviced by trained personnel. There are no consumer serviceable parts inside the pump. The pump motor housing contains a special lubricating oil which should be kept clean and free of water at all times. -
Page 7: Parts List
PARTS LIST Fold tab over cover. 6905 0914 Ref # NAME Qty. PART # Basin Cover Assembly (Includes Nos. 1-8) PW73-65P Basin Cover Square Cut O-Ring Discharge Flange, 1-1/2" Basin Bolt Flat Washer Vent Flange, 2" Cord Grommet Seal Ring Inlet Hub, Snap-In PW73-67 Sump Basin... -
Page 8: Troubleshooting
TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION Pump not plugged in. Check that pump is plugged into a proper outlet. Blown fuse. If blown, replace with fuse of proper size. If voltage is under recommended minimum, check size of wiring from main switch on Low line voltage. - Page 9 PAGE LEFT BLANK INTENTIONALLY MY1001-R (11-15-21)
- Page 10 PAGE LEFT BLANK INTENTIONALLY MY1001-R (11-15-21)
-
Page 11: Warranty
No dealer or other person has any authority to make any different warranties or representations concerning Pentair or Pentair products. Accordingly, Pentair nor any of its entities are to be held responsible for any such warranties or representation. - Page 12 Fx: 888.606.5484 Pentair trademarks and logos are owned by Pentair or its affiliates. Third party registered and unregistered trademarks and logos are the property of their respective owners. Because we are continuously improving our products and services, Pentair reserves the right to change specifications without prior notice. Pentair is an equal opportunity employer.