Page 2
1-908-719-4707, or emailing support@westwoodbaby.com If any aspect of these instructions is unclear, please contact your retailer or Westwood Design for assistance. In addition to meeting our own extensive in-house testing and standards, this crib has been independently tested to meet JPMA certification standards.
Page 3
SHARP EDGES BEFORE AND AFTER ASSEMBLY AND FREQUENTLY DURING USE. DO NOT USE CRIB IF ANY PARTS ARE MISSING OR BROKEN. ASK YOUR DEALER OR CONTACT WESTWOOD DESIGN: 635 N. BILLY MITCHELL RD., STE. B, SALT LAKE CITY, UTAH 84116, PHONE: 1-908-719-4707, EMAIL: SUPPORT@WESTWOODBABY.COM; FOR REPLACEMENT...
Page 4
Parts & Hardware Included Headboard (x1) Footboard (x1) Crib End (Left) (x1) Crib End (Right) (x1) Day Bed Cap, Left ( x1 ) Day Bed Cap, Right ( x2 ) Mattress Support (x1) Allen Wrench (x1)
Page 5
Required Parts & Hardware (A) Headboard (C) Crib End (Left) (D) Crib End (Right) (H) Allen Wrench Step 1...
Page 6
Required Parts & Hardware (G) Mattress Support (H) Allen Wrench Step 2 There are three possible height settings. The mattress support should be at the highest setting for a newborn, then adjust to the lower position as the child grows and becomes mobile. Once the child is able to stand, adjust to lowest position.
Page 7
Required Parts & Hardware (B) Footboard (H) Allen Wrench Step 3 Made in Vietnam...
Page 8
Day Bed Conversion (E) Day Bed Cap, Left ( x1 ) (F) Day Bed Cap, Right (x1 ) (H) Allen Wrench Step 4 The day bed can only be used with the mattress support in its lowest position. Remove the bolts from the footboard using the allen wrench provided.
- Your crib has a durable and protective non-toxic finish. However, if you decide to refinish it, you must use a non-toxic finish specified for children’s products. Do not use any toxic stripping methods to remove the old finish. westwood design 635 N. Billy Mitchell Rd., Salt Lake City, UT 84116 Phone: 908-719-4707 www.westwoodbaby.com...