Jenn-Air JCD2290HE Use & Care Manual page 6

I
NSTALLATION
Leveling
To protect personal property and refrigerator
from damage, observe the following:
• Protect vinyl or other flooring with cardboard, rugs,
or other protective material.
• Do not use power tools when performing leveling
procedure.
To enhance the appearance and maintain performance,
the refrigerator should be level.
Notes:
• Complete any required door reversal, panel
installation and/or a water supply connection
before leveling.
• Some models only have adjustment screws (A).
Materials Needed
• " hex head driver
3 ⁄
8
• Carpenter's level
1. Remove toe grille.
• Grasp firmly and pull
outward to unclip.
2. Using hex head driver, turn front adjustment
screws (A) clockwise to raise and counterclockwise
to lower the front of the refrigerator.
A B
3. Select models also have rear adjustment screws
(B). Using the hex head driver, turn each of these
adjustment screws (B) to raise or lower the rear of
the refrigerator.
4. Using the carpenter's level, make sure front of
refrigerator is 1 " (6 mm) or
⁄
4
back of refrigerator and that the refrigerator is level
from side to side.
5
CAUTION
B
A
1 bubble higher than
⁄
2
5. If required, correct rocking of refrigerator by
turning rear adjustment screw clockwise to raise
rocking corner. If doors are uneven, do the
following:
• Determine which
door needs to be
raised.
• Turn front roller
adjustment screw
(A) clockwise to
raise front corner of
door.
• If one refrigerator door has reached the limit of
its adjustment range and doors are still not level,
raise or lower the opposite door by turning roller
adjustment screw clockwise or counterclockwise.
• Check with level to verify
proper door closure.
• If refrigerator is aligned and stable, replace toe
grille and hinge covers.
• Align the toe grille mounting clips with the lower
cabinet slots.
• Push the toe grille firmly until it snaps into place.
1 " tilt to the back for
⁄
4