Toshiba 42WH36P Service Manual page 18

Adjustment items
Focus adjustment Concerning items 1), 2), 3), and 5) of G adjustment, these are common to the ones
on the previous page.
3. R adjustment
1) Set to the R monochrome by lens cap.
2) Receive the image of the internal crosshatched pattern.
3) Adjust the R electrical focus.
Adjust by focus volume of the focus block (Z410) so that the screen center will
come to optimum focus.
4) Adjust the R lens focus.
Adjust so that the screen center will become the best.
5) Repeat 3, 4, and attempt to further improve the focus quality.
4. B adjustment
1) Set to the B monochrome by lens cap.
2) Receive the image of internal crosshatch
pattern.
3) Adjust the B electrical focus.
Adjust the B electrical focus by using the focus VR on the focus block (Z410)
so that the scanning line is the most distinct at the point of 2/3L left side from
the screen center.
4) Adjust the B lens focus.
Pay attention to the border of the blue line and the black (background) in the vicin-
ity of the screen center.
First of all, make coarse adjustments of the lens, and move the lens adjusting
screw to the right at the point being considered as the best focus. Then, the lines
of the border become clear. Check and confirm under the circumstance that a
flare appears. On the contrary, if the lens adjusting screw is moved to the left from
the situation, the flare will disappear, and at this point you will find a point from
which the borderline itself begins to go out of focus. Adjust to the very point where
the focus begins to go out.
– 18 –
Adjusting methods
L
2/3L