Cleaning And Maintenance - Primo Water SL212C User Manual

cleaning upholstery etc.). Place the attachment correctly on the mouth
opening of the device which is located at the tip of the transparent
dust bowl, making sure that it fits safely on the bowl.
- ATTENTION!: For liquid absorption you must only use the liquid's
suction nozzle (the one with the rubber) and not any of the other
accessories. Do not allow appliance to overfill whilst absorbing liquids
as this may damage the appliance.
- Then put the brush in a horizontal position above the area you want to
clean and activate the device by turning the power switch to the
operating position "ON".
- Caution : When using your appliance you should never turn it with its
mouth facing upwards because the waste that you have collected -
and especially liquids , can cause damage to the filter and your device
as it can block the air inlets/outlets of your device.
- After completing your cleaning task, deactivate your device by sliding
the operation switch to its "OFF" position.
- Empty the dust collected:
Press the dust bowl release button and remove the dust bowl from the
appliance.
Remove the filter and empty the dust bowl.
- Clean the filter thoroughly, especially in the case of liquid's absorption.
- Clean the inner surface of the bowl with a soft cloth, especially in the
case of liquid's absorption.

CLEANING AND MAINTENANCE

1. After each use and before cleaning, unplug the charger base from the
mains and let the appliance and its charger base to cool down
12