Settings; Working - Festool CT 26 E AC Original Operating Manual

English
"Auto" switch position
Appliance socket [1-3] is connected to the pow­
er, the mobile dust extractor starts when the
connected tool is switched on.
7

Settings

7.1 Connecting electric power tools
WARNING
Risk of injury
► Observe the maximum appliance socket
connected load (see chapter "Technical da­
ta")
► Switch off the electric power tool.
► Connect the electric power tool to the appli­
ance socket .
Electrical outlet module circuit breaker
If the maximum connected load at the electrical
outlet module of the power tool is exceeded, the
circuit breaker separates the electrical outlet
module from the voltage supply.
► Turn off the power tool using the switch.
► Wait approx. 20 seconds.
► Activate the circuit breaker [1-4].
► Turn the power tool back on.
7.2 Connecting pneumatic tools
WARNING
Risk of injury
► Switch off the air tool.
If the compressed air module [1-2] (496141) is
installed, the automatic switch-on function of
the mobile dust extractor also works in combi­
nation with air tools.
We also recommend installing the VE service
unit (495886). The service unit filters and lubri­
cates the compressed air and enables an ad­
justment of the air pressure. An IAS adapter
(454757) is available to connect Festool air tools
to the IAS system.
The operating pressure of the tool must be 6
bar for the automatic switch-on unit to function
correctly.
7.3 Adjusting the suction power
► Use the rotary knob [1-7].
7.4 Applying the brake
Folding out the black brake lever [1-13] pre­
vents the mobile dust extractor from rolling. To
achieve this, lift the front end of the mobile dust
extractor slightly and push the black brake lev­
8
er downwards until it latches into place. Push
the green lever [1-14] again to release.
7.5 Temperature cut-out
A temperature cut-out switches the mobile dust
extractor off when it reaches a critical tempera­
ture to prevent overheating.
► A temperature cut-out switches the mobile
dust extractor off when it reaches a critical
temperature to prevent overheating.
► Switch off the mobile dust extractor, allow
to cool for about 5 minutes then switch on
again.
Not possible to switch on: contact
Festool service workshop.
8

Working

8.1 Handling
Hose store: after finisching work, you can feed
the suction hose through the recess [4-2] and
place it in the hose store.
SysDoc Systainer attachment system: a Sys­
tainer can be attached to the storeage area via
the four slides ore the T-Loc [4-1].
8.2 AUTOClean - Cleaning the main filter
To maintain a constant suction power when ex­
tracting fine dust, you can adjust the frequency
of the automatic cleaning system in infinite var­
iables using the rotary knob [1-8]. Always use
the automatic cleaning system in combination
with a disposal bag.
Before performing wet extraction tasks
or working with a filter bag, set the rota­
ry knob [1-8] to position 0.
► Set the automatic cleaning function [1-8] to
the highest setting when extracting large
quantities of dust.
Manual cleaning
Turn the switch [1-9] to the AC symbol.
We recommend cleaning the main filter com­
pletely if severely clogged:
► Cover the end of the nozzle or suction hose
with your hand for 2 seconds.
► Turn the switch [1-9] to the AC symbol.
When the CT-VS closing slide is used
(order no.: 497926), the filter can be
cleaned fully without removing the
connected electric power tools.
In intensive applications that generate adherent
dust, it may be necessary to clean the filter ele­