Kobalt KNA 124B-03 User Manual page 13

OPERATING INSTRUCTIONS
7. Dry-Fire Lockout
When the magazine has 0-6 nails remaining, the dry-fire lockout feature will not allow
continued operation. To resume operation, reload the tool with nails.
8. LED Work Light
The LED work light (C), shown in FIG. 8, will
illuminate when the trigger switch (J) or the
workpiece contact (G) is depressed. This provides
additional lights on the surface of the workpiece for
operation in lower-light areas.
The LED work lights will turn off within
approximately 10 seconds after the trigger switch is
released.
9. Removing a Jammed Brad Nail
a. Remove the battery pack from the tool.
b. Press the magazine release button (D) and
remove the nails from the magazine.
c. Lift the jam release latch (I) and open the jam
release (H).
d. Remove the jammed nail using a flat head
screwdriver or pliers if necessary.
NOTICE: Do not mar/scratch the nail channel
or driver mechanism. The screwdriver should
always slip over the nail when prying.
e. Close the jam release and the latch.
f. Reload the nails and close the magazine.
g. Reattach the battery pack and restart the tool
by pressing the power switch (A).
NOTE: Driving the nails too deeply into the material, excess debris, or jammed nails may lead
to a driver blade being stuck at its bottom position.
The driver blade can usually be returned to its operating position by depressing the work
contact element against a scrap piece of wood and squeezing the trigger.
If the tool cycles without driving a nail, the nail channel may be dirty. See 'Cleaning the Nail
Channel' in the 'Care and Maintenance' section of this manual.
8
9
13
C
Driver
mechanism
H
I