Kobalt KNA 124B-03 User Manual page 11

OPERATING INSTRUCTIONS
4. To Load Or Remove Brad Nails
WARNING:
• Keep the tool pointed away from yourself and
others when loading nails. Failure to do so could
result in possible serious personal injury.
• Use only the nails recommended for use with this
tool. The use of any other nails can result in tool
malfunction, leading to serious injuries.
• Never load nails with the workpiece contact or
trigger activated. Doing so could result in possible
serious personal injury.
To Load Brad Nails
a. Remove the battery pack from the tool.
b. With the nose of the tool pointed away from you, squeeze the magazine release button (D)
located at the rear of the magazine (E) and slide the magazine open.
c. Place the brad nails (5/8" to 2-1/8" [16mm – 54mm] long) in the channel with the nail tips
pointing down and resting on the bottom of the channel.
d. Push the magazine (E) closed until it securely snaps into place.
e. Make sure that the magazine (E) is securely locked in place.
f. Reattach the battery pack, and reactivate the nailer by pressing the power switch (A).
NOTE: You can observe the number of remaining nails through the nail indicator windows (F),
and load more nails as needed.
To Remove Brad Nails
a. Remove the battery pack from the tool.
b. Squeeze the magazine release button (D) located at the rear of the magazine (E) and slide
the magazine open.
c. Remove the nails.
d. Close the magazine and make sure that it is securely locked in place.
5. Depth of Drive Adjustment
It is advisable to test the depth of drive on a scrap
workpiece to determine the required depth for the
application.
Harder materials and longer nails will require more
force to drive the nail.
WARNING: Always point the nailer away from
yourself and others when making adjustments.
Failure to do so may cause serious injury.
a. Remove the battery pack from the tool.
b. Rotate the depth adjustment dial (L) to adjust
the depth as indicated by the depth arrow.
c. Reattach the battery pack and restart the tool by pressing the power switch (A).
d. Drive a test nail after each adjustment until the desired depth is set.
4
5
Deeper
11
P F
Top
Nail tips
L
D
E
Shallower