Introduction; Scanning With The Ls 1004 - Symbol LS 1004 Product Reference Manual

Introduction

This chapter covers the techniques involved in scanning bar codes. Included are specific
instructions on how to hold the scanner at the appropriate angle to ensure an accurate
decode.

Scanning with the LS 1004

1. Make sure all connections are secure.
2. Aim the scanner away from you and press the trigger. When you press the trigger, the
scanning beam is energized for approximately 1 second (default).
3. Make sure the symbol you want to scan is within the scanning range. See the LS 1004
Decode Zone diagram on page 3-6.
Aim and press the trigger. On the LS 1004, if you use the scanner in default Low
Power operating mode, the DECODE LED remains on until power down (maximum
of 1 second). If the unit is programmed for Continuous power operating mode, the
DECODE LED stays on until the next trigger pull.
The scanner has read the symbol when:
You hear a short, high tone beep (if the beeper is enabled).
!
The DECODE LED lights.
!
Scanning
2-3