Table of Contents
Advertisement
16. Press
or
to select characters and then
space until Model Name is complete.
NOTE: Make sure to include dash in Model Name.
Status Information
Self diagnosis history
Panel Selection
Wide Band Tuning
LVDS Spectrum (%)
Tuning System
Status Digital RF Information
Low of HPD
UART Selection
SERIAL NUMBER EDIT
MODEL NAME EDIT
TEST RESET
CAUTION: The Model Name can only be selected once. Be sure
to verify the information is correct before saving the changes.
17. When the complete Model Name displays, press
18. On the confirmation screen, press
Input Data Correct?
Yes
No
Selected text displays in black
19. Press
to exit Service Mode.
POWER
KDL-40R355B
to move to the next
Service Mode
>>
>>
]>
<[
NS4S400DND1101
>>
<[
]>
29
]>
<[
Auto
<[
]>
Off
5
<[
]>
Factory
2000001
KDL-40R355B
Off
<[
Off
]>
[</>]Set [Home] Exit
.
to select YES and then
SECTION 3 - REPAIR INFORMATION
REMOVING THE PANEL ORNAMENTAL
1. Locate and remove 1 screw, then slide the Panel Ornamental from
the left side to detach it as shown.
REMOVING THE H BOARD
2. Disconnect the connector from the H Board as shown.
3. Lift the H Board from the left side and refer to the illustration to make
sure its been detached, then lift it to remove.
.
15
Advertisement
Table of Contents
