Download Print this page

PRO SIGNAL 50-14797 Assembly Instructions Manual

Tv stands

Advertisement

Quick Links

This completes the assembly steps of this stand.
As noted earlier, it is the ultimate responsibility of the user to ensure safe and secure
Installation of any television on this stand. There is no guarantee that every television,
even if within the size and weight limits specified, will be secure in every situation.
Once installation is complete, the user must make certain the television set is secure.
Failure to do so could result in property damage, electrical or fire hazard and personal
injury or death, should the television fall. Pro Signal, MCM Electronics and all retail
dealers providing this product cannot be held liable for damages that result from improper
or insecure installation.
Things to remember:
Furniture including tables, dressers, entertainment centers and shelves must be tested
to ensure stability
Televisions should be installed out of reach of small children or pets that could potentially
pull or knock a set from its location
Connecting cables, including power cords, cable, antenna or satellite TV wires, cables
from other components, indoor antennas and similar items should be secured and tucked
out of the way to prevent being snagged or tripped over
Televisions should not be located in direct sunlight or in locations where they can come in
contact with rain or moisture.
In the event the user is not confident in the safety of this installation it is highly
recommended that a qualified installation professional be contacted.
Warranty
This device is warranted against manufactures defects for a period of 1 year from the original date of
purchase. This warranty covers all internal components and the cost of labor to either repair or replace
the unit. This warranty covers only the unit, and does not cover connected equipment, or any loss that
may occur, regardless of cause. It will be the sole discretion of MCM Electronics to determine the
applicability of said warranty, and determination as to whether the unit will be repaired or replaced.
Questions regarding application, use, or problems with this unit should be directed to MCM Electronics
Tech Support, which can be found at www.mcmelectronics.com.
www.mcmelectronics.com
TV STANDS
Model 50-14797
Model 50-14797
ASSEMBLY INSTRUCTIONS
75x75/100x100
200x100/200x200
300x300/400x200
400x400/600x400
CAUTION:
DO NOT EXCEED RATED
LISTED WEIGHT CAPACITY. SERIOUS
INJURY OR PROPERTY DAMAGE MAY
OCCUR!
70"
50kg
MAX
(110lbs)
RATED
ISSUED: APR. 2014

Advertisement

loading

Summary of Contents for PRO SIGNAL 50-14797

  • Page 1 Failure to do so could result in property damage, electrical or fire hazard and personal injury or death, should the television fall. Pro Signal, MCM Electronics and all retail dealers providing this product cannot be held liable for damages that result from improper or insecure installation.
  • Page 2 Identify and verify all of the included hardware To begin, place the glass base (B1) on a flat surface with the shiny side facing upwards. It is best if this is located on a table, where the mounting holes are able to hang just over the side.
  • Page 3 Place the glass base on a table, glossy side facing downward. Attach the self-adhesive feet, one near each corner, A1x6 one each centered along of the front and rear edge, as shown. Holding the base vertical, and laying the rear supports on the table, attach the rear supports to the base as shown, using (A2) plastic washers, (A3) metal washers and (A4) hex head screws.
  • Page 4 Determine the optimum height on the rear pedestal to attached the (B4) bracket. The best method to do this is to measure from the center of your television screen A3x4 to the bottom most edge of the TV set. This will tell you the minimum clearance needed on this Universal Base.
  • Page 5 Locate the two television mounting brackets (B1). These brackets attach to the rear mounting points on most VESA standard television sets. These are compatible with VESA sizes up to 600 x 400. Using the screws and washers provided, these will attached to the rear of your television set. As all sets differ slightly, it is not possible to provide exact instruction in this document.
  • Page 6 Largest Supplier of Electrical and Electronic Components Click to view similar products for manufacturer: Pro Signal Other Similar products are found below : ABS-210-135-RC KVM-404 JR9502/5M JR8030/25M APFLY5 MJ-2325 ABM-713-RC PSG-BB-170W-2BP PSG01592 PSG01540 PSG01522 PS11169 PS11067 PS11360 PS11155 PS11153 PS11026 PSG03905 ABI-052-RC PSG03109 PSG03489 JR9505/1M...