Download Print this page

PRO SIGNAL 50-14797 Assembly Instructions Manual page 5

Tv stands

Advertisement

5
8
Locate the two television mounting brackets (B1).
These brackets attach to the rear mounting points on most VESA
standard television sets. These are compatible with VESA sizes
up to 600 x 400. Using the screws and washers provided, these
will attached to the rear of your television set. As all sets differ
slightly, it is not possible to provide exact instruction in this
document. If possible, you should refer to your television owner's
manual for this.
Many different screw sizes are provided to accommodate most
every television in the market. The critical issue is to choose screws
that are the correct TPI (threads), diameter, and appropriate length.
Choosing a screw that is too short will cause the mount to not
support the set.
Choosing a screw that is too long may cause you to insert too
far into the rear of your set, thus damaging internal components.
Attach the (B5) brackets to the rear of your set and be certain all
screws are properly and securely inserted.
On the rear of the (B5) brackets, locate the attachment
set screws facing downward. These secure the television
to the assembled stand. Fully loosen these screws until
They are just in their threaded holes.
B5x2
It is now time to hang the television onto the base.
This this will require two people.
Hook the top of the (B5) bracket on to the
assembled stand. The (B5) bracket will hang on the top lip of
the horizontal bracket, with the set screws tightening against the
bottom lip. Tighten the screws against the bottom lip and test
the set to make sure it is secure.
9

Advertisement

loading