Electrolux EW7F249S User Manual page 32

32 www.electrolux.com
13.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem
persists, contact the Authorised Service
Centre.
In case of major problems, the
acoustic signals operate, the display
shows an alarm code and the Start/
Pause
continuously:
• - The appliance does not fill
with water properly. Start the
appliance again by pressing Start/
Pause
door will be unlocked.
• - The appliance does not drain
the water.
• - The appliance door is open or
not closed correctly. Please check the
door!
If the appliance is
overloaded, remove
some items from the
drum and/or hold the
door shut while touching
the Start/Pause
button until the indicator
the picture below).
13.2 Possible failures
Problem
The programme does
not start.
button may flash
button. After 5 seconds the
stops flashing (see
Possible solution
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that the appliance door is closed.
• Make sure that there is no damaged fuse in the fuse
box.
• Make sure that the Start/Pause
• If the delay start is set, cancel the setting or wait for the
end of countdown.
• Deactivate the Child Lock function if it is on.
• Check the position of the knob on the selected pro‐
gramme.
• - The mains supply is unstable.
Wait until the mains supply is stable.
• - No communication between
electronic elements of the appliance.
Switch it off and switch on again. The
programme was not finished properly
or the appliance stopped too early. If
the alarm code appears again,
contact the Authorised Service
Centre.
WARNING!
Deactivate the appliance
before carrying out any
check.
has been touched.