Page 1
Owner’s manual Mode d’emploi Manual de instrucciones CX609 ® 2-DIN Bluetooth CD/USB/MP3/WMA/AAC RECEIVER WITH CeNET CONTROL LECTEUR CD/USB/MP3/WMA/AAC 2 DIN Bluetooth AVEC COMMANDE CeNET RECEPTOR CD/USB/MP3/WMA/AAC TAMAÑO 2-DIN, CON ® Bluetooth Y CONTROL CeNET ®...
Page 2
Once you’re registered, we can keep you informed of important product information. Register at www.clarion.com - it’s easy to keep your Clarion product up to date. INFORMATIONS DE L’ENREGISTREMENT DE PRODUITS CLARION Cher client: Nous vous remercions d’avoir acheté...
Thank you for purchasing this Clarion product. ∗ Please read this owner’s manual in its entirety before operating this equipment. ∗ Check the contents of the enclosed warranty card and keep it carefully with this manual. Contents 1. FEATURES ... 3 2.
Bottom View of Source Unit CX609 CAUTION USE OF CONTROLS, ADJUSTMENTS, OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN, MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
[x], [v] buttons • Commence fast-forward or fast-reverse mode. [ROTARY] knob • Rotate to adjust the volume. ] button • Press to switch to the sound adjust mode. [SRC] button • Turn the power on/off. [DIRECT] [DISP] [BND] [AUX] CX609...
• Press and hold the button (2 sec.) to store current station in ISR memory (radio mode only). [DISP] button • Press to select the desired display. CX609 ● Radio/Satellite Radio modes Signal transmitter [BND] button • Switches reception band.
• When replacing the battery, insert properly, with +/– polarities oriented correctly. • Do not subject battery to heat, or dispose of in fire or water. Do not attempt to disassemble the battery. • Dispose of used batteries properly. CX609...
1. Turning the [ROTARY] knob clockwise increases the volume; turning it counterclockwise decreases the volume. ∗ The volume level is from 0 (minimum) to 33 (maximum). CX609 Switching the display Press the [DISP] button to select the desired display. Sound Adjustment You can adjust a sound effect or tone quality to your preference.
The setting changes in the following order: “THROUGH” ↔ “60” ↔ “90” ↔ “120” ∗ The factory default setting is “THROUGH” (through). CX609 Setting the BBE MP (Sound Enhancement and Restoration for compressed audio files) “THROUGH ”.
● Recalling a station with ISR In any mode, press the [ISR] button to turn on the radio function and tune the selected radio station. “ISR” appears in the display. Press the [ISR] button again to return to the previous mode. ] button CX609...
1. Press the [DISP] button to select the desired channel label. Channel ➜ Category ➜ Name (Title) ➜ Channel ... CX609 Channel input directly This function allows you to input the channel No. directly. 1. Press and hold the [DISP] button for 1 second or longer to switch to the adjustment selection display.
Category scanning is not available when no category is defined for the current channel. ] button to ] button to switch to ] / [ ] button or [DIRECT] ] button for 1 second ] button for 1 second CX609...
ISO as the writing software format. Normal play may not be possible if the disc is recorded on another format. CX609 2. The folder name and file name can be displayed as the title during MP3/WMA/AAC play but the title must be within 64 single byte alphabetical letters and numerals (including an extension).
● Track-down 1. Press the [x] button to move back to the beginning of the current track. 2. Press the [x] button twice to move back to the beginning of the previous track. mark and ] button CX609...
This function allows you to play the current track repeatedly. 1. Press the [RPT] button to perform repeat play. CX609 ● Folder repeat play This function allows you to play a track currently being played in the MP3/WMA/AAC folder repeatedly.
[x] or [v] button to select the contact name’s phone number. ] button. ] button (1 sec.) to ] button to end the call. ] button to call the mobile ] button to end the call. ] button to reject an incoming CX609...
Page 18
[w] or [z] button to select “MEMORY 1” to “MEMORY 5”, then press and hold the ] button (1 sec.) to memory. CX609 4-1. Press the [w] or [z] button to select “SEARCH” or “WAIT”. 5-1. Press and hold the [ ] button (1 sec.).
Page 19
3-1. Press the [w] or [z] button to select “LOW” or “HIGH”. ∗ The factory default setting is “LOW”. MEMORY MEMORY MEMORY MEMORY 0 piece 0 piece 0 piece piece piece piece piece piece piece piece AUTO ”. CX609 piece piece...
● Bluetooth Name This will display the name of the Bluetooth. 2-1. Select “BT NAME”. The Bluetooth name appears in the display. CX609 ● Bluetooth Firmware version This will display the Firmware version of the Bluetooth. 2-1. Select “BT FW”.
● Setting the anti-theft function (CATS) “CATS” is the acronym of “Clarion Anti-Theft System”. When you set a PIN code (called as “Personal Code”), a theft is prevented by disabling the operation of the unit at the theft.
Page 22
• The [RESET] button was pressed. Note: • If you have lost your Personal Code, please contact Clarion customer service. 1. Enter your Personal Code currently set. 2. When the correct Personal Code is entered, the unit will restart from the initial startup screen.
Capital letters ➜ Numbers ➜ Symbols ➜ Capital letters… 8. Press the [w] or [z] button to select the desired character. 9. Repeat steps 6 to 8 to enter up to 10 characters for the title. 50 titles 30 titles 100 titles CX609...
1. Press and hold the [DISP] button (1 sec.). 2. Select “AUX SENS”. 3. Press the [w] or [z] button to select “HIGH”, “MID” or “LOW”. Note: • When AUX mode is selected, AUX IN sensitivity can be set. CX609...
For information regarding supported portable audio players, consult your nearest Clarion dealer, or visit Clarion's website. • Insert and remove a USB memory/MTP device only when the device is not being accessed. Connecting or disconnecting...
Page 26
(the actual playback order may not be the same as that indicated on your computer’s display). CX609 To listen to tracks on a connected USB memory/MTP device 1. Press the [SRC] button to switch the source.
• The unit will not operate, or may operate improperly with unsupported versions. • For a list of compatible Apple iPod unit with the this model, please contact your Clarion dealer or www.clarion.com. • “Made for iPod” means that an electronic...
Page 28
[v] button. Playback will begin from the first track in the selected category, and the iPod menu mode will be canceled. CX609 ∗ Subfolders may be displayed, depending on the category. In this case, use the [w] and [z] buttons to switch between subfolders, then use the [v] button to select the desired subfolder.
Page 29
This unit supports the display of title information transmitted from a connected iPod. • Character code information is UTF-8; displayable characters include English alphanumerics, some symbols, and some umlaut characters. • Unsupported characters will be replaced by asterisks (*). CX609...
1. Press the [DISP] button to select the desired channel label. Channel ➜ Category ➜ Title (Artist) ➜ Radio text ➜ Channel... CX609 Channel selection 1. Channels are selected with the [x] or [v] button. ∗ For details, see the following operation descriptions.
Page 31
10 seconds. Press the [ ] button to select the category scan mode. And start the category scanning. Note: • Category scanning is not available when no category is defined for the current channel. CX609...
• If a CD-text CD is not input its disc title or a track title, “NO TITLE” appears in the display. CX609 Procedure to scroll a title Set “SCROLL” to “ON” or “OFF”. (The factory default setting is “ON”. Refer to the subsection “Setting the method for title scroll”...
1. Turn down sound volume. Function can also be restored by turning the power off and on again. (Speaker volume is reduced automatically when the speaker protection circuit operates). 2. If the sound is muted again, consult our service department. Measure Reset button CX609...
Page 34
Can’t insert the The device has been inserted device. improperly. The connector is broken. CX609 Cause Write MP3/WMA/AAC files onto the disc properly. Use MP3/WMA/AAC files encoded properly. Use ISO9660 level 1, 2 or JOLIET or Romeo or APPLE ISO file system.
Eject the disc then reload it properly. Use only properly encoded MP3/WMA/AAC files. Use only properly encoded MP3/WMA/AAC files. Disconnect the devices and reconnect. If the devices are still not recognized, try replacing with a different devices. Do not use the HUB devices. Measure CX609...
AVRCP (Audio/Video Remote Control Profile) Send/Receive Sensitivity: Class 2 Note: • Specifications and design are subject to change without notice for further improvement. CX609 Audio Maximum Power Output: 200 W (50 W ✕ 4 ch) Bass Control Action (100 Hz): +14 dB, –14 dB Treble Control Action (10 kHz): +14 dB, –14 dB...
Microsoft may include a revocation list with the licenses. Content owners may require you to upgrade WMDRM to access their content. If you decline an upgrade, you will not be able to access content that requires the upgrade. CX609...
Need help?
Do you have a question about the CX609 and is the answer not in the manual?
Questions and answers