Table of Contents
Advertisement
POWER
1. Start On
Press button POWER for 2 seconds for start On, displaying
interface.
2. Power Off
Press POWER for 2 seconds, shut down and power off.
4.3. Keypad operation
Keypad panel includes control buttons, back-pressure switch and LCD adjusting keys.
1
Control buttons:
UP Value increasing or Cursors upward moving.
SAVE Save the current test results
SET
MENU On the main screen holding this down for 2 seconds
OK In t
While
START Begin a measurement in main menu
STOP Stop a measurement in main menu
BACK Cancel or end an operation or return to the previous screen
EXIT Return to the main menu
ESC Stop printing when printing
DOWN: Value decreasing or Cursors downward moving
2
Back pressure switch for on/off
Note
1) If you are not in the back pressure mode, shut down the back pressure plate and lock the
switch to avoid testing errors.
2) If the airflow is greater than 1500m
recommended according to testing procedures.
www.lazodecontrol.com
UP/SAVE
SET/MENU/OK
START/STOP/
BACK/EXIT/ESC
DOWN
, pressing for 2 seconds will save the date or time ;
, pressing for 2 seconds will delete saved data.
3
/h (883CFM), testing in back-pressure Mode is
13
+51 960 810 089
2014 / 03 / 20
Atmos:
20.5
START
KANOMAX then enter into the
START/STOP
13 : 10
ID:
01
Ready
3
m
/h
Cycle:
99.0
kPa
001
30.7
%RH
Mode:
Single
SAVE
MENU
testing
SAVE
ventas@lazodecontrol.com
Advertisement
Table of Contents
