Troubleshooting; Specifications - JVC CA-MXJ50A Instructions Manual

Compact component system
Hide thumbs Also See for CA-MXJ50A:
Table of Contents

Advertisement

Troubleshooting

If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Symptom
No sound is heard.
Hard to listen to broadcasts because of
noise.
The disc sound is discontinuous.
The disc tray does not open or close.
The disc does not play.
The cassette holders cannot be opened.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the remote
control unit.

Specifications

Amplifier section — CA-MXJ50
Output Power
120 watts per channel, min. RMS, driven into 6 ohms at 1 kHz
with no more than 10% total harmonic distortion.
Audio input sensitivity/Impedance (at 1 kHz)
AUX:
520 mV/50 kohms
Digital output: CD OPTICAL DIGITAL OUTPUT
Signal wave length: 660 nm
Output level: –21 to –15 dBm
Speakers/Impedance: 6 – 16 ohms
Tuner
FM tuning range: 87.5 – 108.0 MHz
AM tuning range: 530 – 1,710 kHz
CD player
CD Capacity:
3 CDs
Dynamic range:
85 dB
Signal-to-noise ratio: 90 dB
Wow and flutter:
Immeasurable
Cassette deck
Frequency response
Normal (type I):
CrO
(type II):
2
Metal (type IV):
Wow and flutter
0.15% (WRMS)
EN17-24.MX-J50[J]/f
Connections are incorrect or loose.
• Antennas are disconnected.
• The AM loop antenna is too close to the
unit.
• The FM antenna is not properly extended
and positioned.
The disc is scratched or dirty.
• The AC power cord is not plugged in.
• Trays are locked.
The disc is placed upside down.
Power supply from the AC power cord has
been cut off while the tape was running.
Small tabs on the back of the cassette are
removed.
The built-in microprocessor may
malfunction due to external electrical
interference.
• The path between the remote control unit
and the remote sensor on the unit is
blocked.
• The batteries are exhausted.
50 — 14,000 Hz
50 — 14,000 Hz
50 — 14,000 Hz (only for playback)
24
Cause
Check all connections and make
corrections. (See pages 6 to 8.)
• Reconnect the antennas correctly and
securely.
• Change the position and direction of the
AM loop antenna.
• Extend the FM antenna at the best
position.
Clean or replace the disc. (See page 23.)
• Plug the AC power cord.
• Unlock the trays. (See page 15.)
Place the disc with the label side up.
Turn on the unit.
Cover the holes with adhesive tape.
Unplug the AC power cord and then plug it
back in.
• Remove the obstruction.
• Replace the batteries.
Design and specifications are
subject to change without notice.
General
Power requirement:
AC 120 V , 60 Hz
Power consumption:
100 watts / 130 VA (at operation)
14 watts (on standby)
Dimensions (approx.): 265 x 315 x 341 mm (W/H/D)
(10
7
Mass (approx.):
9.4 kg (20.7 lbs)
Supplied accessories
See page 6.
Speaker section — SP-MXJ50
T
ype:
4-way bass-reflex type
Labyrinth Aeroport System
Speaker units:
Woofer:
Midrange:
Tweeter:
Super tweeter: 2 cm (
Power handling capacity: 120 watts
Impedance:
6 ohms
Frequency range:
40 Hz — 28,000 Hz
Sound pressure level: 87 dB/W•m
Dimensions (approx.): 215 x 315 x 273 mm (W/H/D)
1
(8
/
2
Mass (approx.):
3.9 kg (8.6 lbs) each
– 24 –
99.2.1, 4:00 PM
?
Action
/
x 12
7
/
x 13
7
/
in.)
16
16
16
16 cm (6
5
/
") cone x1
16
5 cm (2") cone x1
4 cm (1
5
/
") cone x1
8
13
/
") dome x1
16
7
3
x 12
/
x 10
/
in.)
16
4
?
?

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mx-j50aMx-j50jMx-j50

Table of Contents