Table of Contents
Advertisement
Quick Links
Foam Managert System
with Advantust
Waterous Company 125 Hardman Avenue South, South St. Paul, Minnesota 55075 USA (651) 450−5000
Instructions subject to change without notice.
Operation and Maintenance
Form No.
Section
F−1031
2407
Table of Contents
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Foam Manager with Advantus
Read through the safety information and operating
instructions carefully before using your Waterous
Foam Manager.
Visit us at www.waterousco.com
Issue Date
Rev. Date
01/18/08
05/13/13
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
2
3
3
4
4
4
5
6
6
6
6
6
6
6
6
6
7
7
8
Advertisement
Table of Contents
Related Manuals for Waterous Advantus Foam Manager
Summary of Contents for Waterous Advantus Foam Manager
-
Page 1: Table Of Contents
Foam Manager with Advantus Read through the safety information and operating instructions carefully before using your Waterous Foam Manager. Visit us at www.waterousco.com Waterous Company 125 Hardman Avenue South, South St. Paul, Minnesota 55075 USA (651) 450−5000 Instructions subject to change without notice. -
Page 2: Safety Information
Safety Information Read through the safety information and operating instructions before using your Waterous Foam Manager. WARNING WARNING Death or serious personal injury might occur if proper Scalding Water Hazard. May result in serious burns. operating procedures are not followed. The pump op-... -
Page 3: Introduction
The Foam Managert System consists of an Advantust load of 40 amps @ 12 VDC or 21 amps @ 24 VDC (Ad- Foam Management System mounted on a Waterous CM vantus 3) or 80 amps @ 12 VDC or 40 amps @ 24 VDC or CS fire pump. -
Page 4: System Components
Running the unit without adequate water flow or an Pumps overheated water supply can cause damage to the pump. • F−1031, Section 2115, Operation and Maintenance Instructions for Waterous CS and CSU Series Centrif- ugal Fire Pumps F−1031, Section 2407 Page 4 of 8... -
Page 5: Advantust Foam Pump Operation
Advantust Foam Pump Operation Upon power up, the software revision number will be dis- Figure 2. Operator Interface Terminal played. The unit will then display the flow rate. Because the conductivity measurement for a given per- centage mix changes with the flow rate, the calibration data is stored in an array. -
Page 6: Foam Operation
Foam Operation After the pump is operating, turn on the foam pump to in- Refer to Advantus Foam Pump Operation Instructions on ject foam concentrate into the water stream. Page 5. Foam System Flush 1. Turn off Foam Pump. 2. Flow clear water through discharges that were used until clear water is flowing from the nozzle. -
Page 7: Calibration
Calibration Advantust Foam Pump Only units of measure, water flow and the foam percent- The Advantust system is able to be field calibrated using the control function buttons on the operating interface ter- age default can be field set. minal (OIT), see Figure 8. A. -
Page 8: Troubleshooting Guide
Troubleshooting Guide It is important to know what to do if your foam system in not operating properly. This troubleshooting guide should help you diagnose, isolate and fix the problem encountered. Problem Cause Using wetting agent in place of foam Flush system and install Class “A”...