Clarion MAX973HD Owner's Manual page 184

Wire Connection
Power supply lead
10A
2
Note:
*1: In certain vehicles - Volkswagen/Opel/Vauxhall - it is necessary to exchange the accessory <Red> and the
main power <Yellow> connection, to avoid overload and loss of memory.
Notes on installing the RDS-TMC antenna
• For vehicles that do not allow radio wave penetration such as heat reflection glass, heat insulation
glass or radio wave interception glass, the receiver sensitivity may decrease. For details, speak to the
dealer where you purchased the unit.
• The receiver sensitivity may weaken by interference from other antennas within the vehicle, therefore
try to install it away from other antennas.
• To prevent noise, wire the antenna cable separately from the power supply lead, speaker leads and
the other cables of the vehicle.
88
MAX973HD
1
∗1
No.
∗1
B-2 B-3 B-5
B-1 B-4
A-6
A-4
Description
REAR RIGHT+
REAR RIGHT-
FRONT RIGHT+
FRONT RIGHT-
FRONT LEFT+
FRONT LEFT-
REAR LEFT+
REAR LEFT-
∗
+12 V MAIN POWER ( 1)
TUNER +B
ILLUMINATION
∗
+12 V ACCESSORY ( 1)
EARTH
ISO CONNECTOR
Spare terminal (Yellow)
B-6
B-7
B-8
A-7
A-8
A-5