Download
Share
Print this page
Hunter 146-59-1 Setup Instructions
  1. Manuals
  2. Brands
  3. Hunter Manuals
  4. Remote Control
  5. 146-59-1
  6. Setup instructions

Hunter 146-59-1 Setup Instructions

Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
Setup Instructions for Remote Control
(146-59-1, 146-65-1, 146-78-1)
6754-T, 08-22, Supersedes, 6754-T, 02-16
This procedure should be performed only by an authorized factory representative.
This document provides information for installation and setup of the XF remote controller. Second genera-
tion remotes require a different procedure to set the wireless channel.

Advertisement

loading

Related Manuals for Hunter 146-59-1

Summary of Contents for Hunter 146-59-1

  • Page 1 Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1) 6754-T, 08-22, Supersedes, 6754-T, 02-16 This procedure should be performed only by an authorized factory representative. This document provides information for installation and setup of the XF remote controller. Second genera- tion remotes require a different procedure to set the wireless channel.

  • Page 2: Setup For Remote Control

    Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1) Setup for Remote Control Console Channel Selection NOTICE In most cases, the wireless channel should be correctly set from the factory. Use this procedure if there is a wireless channel conflict. 1. From the setup menu, under “Sensors”, select “Cordless Channel Selection”.
  • Page 3 Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1) Second Design (146-59-1, 146-78-1, 146-65-1) SETTING UP THE REMOTE CHANNEL The wireless channel is selected using a set of dip switches on the main board. To set the wireless channel,remove the four screws securing the back cover of the device, then remove the back cover.
  • Page 4 Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1) Remove the batteries from the device, then remove the three screws securing the main board.Gently turn the board over to access the dip switches on the opposite side. NOTICE You can leave the ribbon cable and power wires connected, the dip switches can be accessed without disconnecting them.

  • Page 5: Battery Replacement

    Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1) Re-install the board, install the batteries, then in- stall the back cover. Make sure the data port plug is in place while assembling the case halves. Check the remote for proper operation.

  • Page 6: Troubleshooting

    Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1) Troubleshooting If the remote is still not connecting to the WinAlign console after several retries, refer to the steps below to possibly identify a problem. 1. Verify XF pod or receiver board is connected to the PC. There should be a indicator light on the pod showing that they are receiving power from the console.
  • Page 7 Setup Instructions for Remote Control (146-59-1, 146-65-1, 146-78-1) 1. This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil contient des émetteurs / récepteurs exempts de licence qui sont conformes aux RSS ex- emptes de licence d'Innovation, Sciences et Développement économique Canada.

This manual is also suitable for:

146-65-1146-78-1