Using Recording Timer - JVC SP-MXJ33U Instructions Manual

6
When selecting "– CD – – –"
1) Press 4 or ¢ to select the disc
number, then press SET.
2) Press 4 or ¢ to set the track
number, then press SET.
The unit enters volume setting mode.
When selecting "TUNER FM" or
"TUNER AM"
Press 4 or ¢ to select the preset station number, then
press SET.
The unit enters volume setting mode.
7
Press 4 or ¢ to set the volume
level.
• You can select the volume level from
among four levels. If you select " VOL – – –," the
volume is set to the last level when the unit has been
turned off.
S.MODE
DAILY
ST
8
Press SET to complete the Daily
Timer setting.
The DAILY indicator stops flashing and remains
lit. The settings you have done are shown on the
display in sequence.
9
Press to turn off the unit (on
standby) if you have set the Daily
Timer with the unit turned on.
To turn on or off Daily Timer after its setting is done
1 Press TIMER/CLOCK repeatedly until
"DAILY" appears on the display.
2 To turn off the Daily Timer, press CANCEL.
The DAILY indicator goes off from the display.
The Daily Timer is canceled, but the setting for
the Daily Timer remains in memory.
To turn on the Daily Timer, press SET.
The DAILY indicator lights up on the display.
The settings you have done are shown on the
display in sequence for your confirmation.
If the unit is turned on when the timer-on time comes
Daily Timer does not work.

Using Recording Timer

PRESET
With Recording Timer, you can make a tape of a radio
broadcast automatically.
How Recording Timer actually works
SET
The unit automatically turns on, tunes into the specified
station, sets the volume level to "0," and starts recording
when the on-time comes (the
the on-time, and continues flashing while the timer is
operating). Then, when the off-time comes ("OFF" appears
just before the off-time), the unit automatically turns off
(stands by).
PRESET
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting the timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press TIMER/CLOCK repeatedly
and start from step 1 again.)
On the unit ONLY:
1
Put a recordable cassette into deck B.
SET
2
Press TIMER/CLOCK until "REC"
appears on the display.
The REC indicator also starts flashing on the
display.
STANDBY
• Each time you press the button, the timer setting modes
change as follows:
TIMER
/CLOCK
Canceled
DEMO
3
CANCEL
Press TIMER/CLOCK again.
"ON TIME" appears for 2 seconds, then the
unit enters on-time setting mode.
SET
– 20 –
indicator flashes just before
S.MODE
REC
ST
ON TIME
DAILY
Clock
ON TIME
setting
(See page 9.)
S.MODE S.MODE
REC
S.MODE
REC
Continued
TIMER
/CLOCK
REC
TIMER
/CLOCK