Related Manuals for Timotion TDH24P
Summary of Contents for Timotion TDH24P
- Page 1 Hand Control Programming-TDH24P 20210827 User Manual Hand Control Programming- TDH24P Version 1 August 2021 1 of 8...
- Page 2 Hand Control Programming-TDH24P Contents Contents ..................................2 Disclaimer .................................. 3 1. User Interface Guide ............................. 4 2. Reset ..................................5 3. Adjusting the Height ............................. 5 4. Setting the Memorized Position ........................... 5 5. Presetting the Desk Starting Height ........................6 6.
- Page 3 Hand Control Programming-TDH24P Disclaimer This user manual is ONLY for generic TiMOTION products. Manufacturers may have altered product settings causing them to differ from this user manual. Please contact the manufacturer for a revised manual if the product settings are different than this manual.
- Page 4 Hand Control Programming-TDH24P 1. User Interface Guide Display Up: Tilt the toggle switch up Down: Tilt the toggle switch down Memory setting button (back) Version 1 August 2021 4 of 8...
- Page 5 3. Adjusting the Height Tilt up or down until the desk reaches the preferred height. 4. Setting the Memorized Position TDH24P supports a maximum of 2 memory positions. How to memorize a position: (1) Adjust the desk to the desired height.
- Page 6 Hand Control Programming-TDH24P If either P1 or P2 is higher than the current height of the table, press and hold the memory setting button and tilt up the Toggle switch. Then, the toggle switch will indicate the height of the memorized position and move to the lower memorized height FIRST.
- Page 7 Hand Control Programming-TDH24P 7. Error Codes The digital display shows the error codes (below) suggesting the issues users may encounter during operation. (Note 3) Error code Descriptions Resetting Not reset completely Overuse protection Unbalance protection Anti-collision T-touch Protection M1 Motor over-current protection...
- Page 8 Hand Control Programming-TDH24P 8. Power Saving Function - Waking Up the Control The digital display automatically turns off if no buttons are pressed within 25 seconds. Press any button to light up the display again. The system goes into <0.1W standby mode if no buttons are pressed within 30 seconds.
Need help?
Do you have a question about the TDH24P and is the answer not in the manual?
Questions and answers