Related Manuals for NBB HyPro-6
Summary of Contents for NBB HyPro-6
- Page 1 NBB Controls + Components GmbH Flexibly designed complete solutions Radio Control Systems – Cable Control Systems – Infrared Control Systems Operating instructions HyPro-6 / HyPro-8 Compact-V 9600 Baud Transmitter Transmitter Receiver...
- Page 2 NBB Controls + Components GmbH...
-
Page 3: Table Of Contents
Contents General information ..............4 Transmitter HyPro-6 /HyPro-8 ..........6 Receiver Compact-V 9600 Baud ..........12 Accessories ................16 Technical documents ............... 20... -
Page 4: General Information
Disregarding these recommendations puts you and others in danger! NBB refuses any warranty and liability in such cases. The radio control system is used to control machines and transmit data. In explosive atmospheres or for the control of machines for the transport of persons it may not be used, unless specifically authorized by the manufacturer for this application. - Page 5 – Check regularly for worn parts. Warranty NBB grants a functional warranty of 12 months from the date of sale on all NBB radio control systems (transmitter, receiver, charger). Working hours and material costs are included in the warranty. Shipping costs shall be at the expense of the buyer.
-
Page 6: Transmitter Hypro-6 /Hypro-8
NBB Controls + Components GmbH Transmitter HyPro-6 / HyPro-8 Variations HyPro-6 HyPro-8 HyPro-6 with Rubber boot (optional) Carrying system with waist- and neckbelt Side protectors No.: 3.320.1010 Waistbelt No.: 3.300.1647 No.: 3.320.1011 Neckbelt Edition 06/16... - Page 7 1. Press in the locking pin If the NBB radio control system won’t be used for a long period of time, it is strongly recommended remove the battery from transmitter and charge the battery approx. every 4 weeks. This prevents deep discharge of the battery and enhances its service life.
- Page 8 NBB Controls + Components GmbH Transmitter HyPro-6 / HyPro-8 Operation of the system > Switching the transmitter on and off Design with emergency stop – Unlock the Emergency Stop pushbutton by turning clockwise to switch on the transmitter. – Two acoustic signal sounds.
- Page 9 > Channel number During operation the set channel is shown in the right upper corner of the LC-display. Please refer to the technical documents for the exact position of the “On/Horn” and “Frequency switching” buttons. > Battery life warnings Only one bar in the battery indicator symbolizes the end of battery capacity. From that moment the transmitter can be operated for approximately another 30 minutes.
- Page 10 NBB Controls + Components GmbH Transmitter HyPro-6 / HyPro-8 Surface Mounted Joystick > Changing the Surface Mounted Joystick – Switch off the transmitter and remove the battery. – Loosen all 4 screws of the Surface Mounted Joystick with a Torx 10 screwdriver and remove the screws.
- Page 11 Baud rate 1,200 / 9,600 baud (bit/sec.) Range Up to 100 m (depending on environment) Operating voltage Battery 7.2 V NBB Current consumption Approx. 30 mA – 100 mA (according to technical execution) RF output < 10 mW ERP Protection class...
-
Page 12: Receiver Compact-V 9600 Baud
NBB Controls + Components GmbH Receiver Compact-V 9600 Baud Variations Compact-VC Compact-VB Compact-VD Compact-VE Edition 12/15... - Page 13 Commissioning The receiver is connected by a connection cable or plug to the system to be controlled. Please observe the instructions of the system manufacturer when installing. We strongly recommend establishing this connection via a central, easily accessible plug connection (e. g. Tyco type (HTS) plug connection, series HE/HB/HN/HA, or a comparable one from a different manufacturer) to enable a fast and precise error diagnosis for servicing and to be able to remove the receiver without installation work.
- Page 14 Receiver Compact-V 9600 Baud Function control To maintain operational safety, a regular function check of the NBB radio remote control is necessary. In single-shift day-to-day operation, we recommend performing this check at least once a week. Checking is possible by using the display lights provided on the receiver. Therefore, the transmitter must be set to the ready-to-operate state.
- Page 15 Technical data Receiver Compact-V 9600 Baud Operating ambient temperature – 20 °C to + 70 °C Protection class IP 65 Receive frequency range See nameplate Data security Addressing each receiver by a separate, unique Binary bit combination >16 million options Safety EMERGENCY STOP with self-test, Restart lockout in the event of a faulty EMERGENCY STOP relay Contact load of EMERGENCY STOP relay...
-
Page 16: Accessories
NBB Controls + Components GmbH Accessories Battery 7.2 V and charger for 7.2 V battery NiMH battery (7.2 V) Charger for charging NiMH rechargeable batteries (7.2 V) Edition 01/20... - Page 17 Battery 7.2 V Completely charge the battery before initial use. The battery only has its maximum capacity after five complete charging and discharging procedures! Completely discharge the battery in the control unit before charging again. The charging time depends on the type of battery. It is normal for the battery to heat up during charging or over long periods of use.
- Page 18 NBB Controls + Components GmbH Accessories Charger for charging NiMH rechargeable batteries (7.2 V) Display of the charging procedure via a DUO-LED: LED – continuously lights up green: STANDBY. Charger is ready for operation. Insert the battery in the battery compartment.
- Page 19 Installation information Please refer to the drawing for the measurements for attachment. Measurements in mm Optional integrated charger (in receiver) Integrated charger (in receiver) for charging NiCd and NiMH rechargeable batteries (7.2 V). Alternatively the receiver (DC supply) can be equipped with an integrated charger. Quick charging (approx.
- Page 20 NBB Controls + Components GmbH...
-
Page 21: Technical Documents
Technical documents... - Page 23 Release the buttons “S1”, “S5” and “S6”. EMERGENCY STOP After that press the switch and release it after 2 seconds, to switch into the working mode. NBB Controls+Components GmbH Otto-Hahn-Str. 3-5 D-75248 Ölbronn-Dürrn Tel.: 07237-999-0 Fax: 07237-999-199...
- Page 24 NBB Controls + Components GmbH 24.02.2021 Change of the system address The transmitter must be switched off. Press and hold the buttons “S9” and “S10” at the same time and release Emergency Stop switch. The actual system address is shown on the display.
- Page 25 ®...
- Page 26 135,5 Compact V PROG.-CONNECTION EU COUNTRIES: www.nbb.de...
- Page 28 E-ME01A10 Out 8 Out 4 Out 8 B Out 4 B Shunt Shunt Out 8 A Out 4 A Out 7 Out 3 Out 7 B Out 3 B Shunt Shunt Out 7 A Out 3 A Out 6 Out 2 Out 6 B Out 2 B Shunt...
- Page 29 ®...
- Page 30 CONNECTION PLAN RECEIVER Serial No.: Cable length : Type : Cable loop No. : 3.400.7090 2x2,5mm² Client : Cable length : Cable loop No. : 3.400.7011 15x0,75mm² Cable length : Date : Cable loop No. : 3.400.7091 01.12.2020 2x1mm² User : Plug No.
- Page 31 CONNECTION PLAN RECEIVER Serial No.: Type : RECEIVER CONTROL CABLE SYSTEM Terminal strip No. Function Wire No. / Pin No. : Terminal strip No./ Plug socket No. : AGND X22.1 Analog DAC Out DAC Out X22.2 OUTPUT Vcc Flex X2.2 Vcc Flex X12.1 Flex In 1...
- Page 32 1 - 1 CONNECTING PLAN CAN CABLE TRANSMITTER - RECEIVER Serial no.: Cable length: ~ 10m Model: Cable loop-no.: 3.400.7022 (4 x 0,75 mm²) Producer: Plug transmitter: 3.910.1032 (male) Date: 26.07.2021 Plug cable transmitter side: 3.910.1034 (female) Plug receiver: 3.960.1033 (female) Name: J.
- Page 33 ®...
- Page 34 DATASHEET TRANSMITTER Serial No. J. Rittmann Date : 23.07.2021 User : HyPro-6 Part Number REMARKS FREQ. BAND F2-Band ACTIVE / PASSIVE LBT-MODE AUTO OFF 60min CHARGER UPPER PART 3.300.1124 blue LOWER PART 2.250.1077 black FACEPLATE 1 silver, lasered 3.820.1439 FACEPLATE 2 silver, printed 3.820.1302...
- Page 35 DATASHEET RECEIVER Serial No. J. Rittmann Date : 23.07.2021 User : Compact-V Part Number REMARKS FREQ. BAND F2-Band ACTIVE / PASSIVE 0,5s POTTED UPPER PART 2.250.1500 black LOWER PART 3.300.1503 black FACEPLATE silver, printed 3.820.1195 BOARD 1 2.100.1571_V012 E-ME01A10 V1/2 mainboard Compact V BOARD 2 2.100.1270_V015...
- Page 38 NBB Controls + Components GmbH...
- Page 40 NBB Controls + Components GmbH Otto-Hahn-Straße 3 – 5 75248 Ölbronn-Dürrn GERMANY Fon: +49 7237 999-0 Fax: +49 7237 999-199 sales@nbb.de www.nbbcontrols.de Edition 05/18 · We reserve the right to alter specifications without notice.