Basic Operations; Daily Operational Procedure; Turning On The Power; Selecting The Source To Play - JVC RX-5052S Instructions Manual

Basic Operations

The following operations are commonly used when you play any sound sources.
Operations hereafter will be explained using the buttons on the front panel.
You can also use the buttons on the remote control for the same functions if they have the same and similar names/marks.

Daily Operational Procedure

1 Turn on the power.
• See "Turning On the Power" below.
2 Select the source.
• See "Selecting the Source to Play" to the right.
3 Adjust the volume.
• See "Adjusting the Volume" on page 10.
4 Select the Surround or DSP modes.
• See "Activating the Surround Modes" (page 28) and
"Activating the DSP Modes" (page 30).

Turning On the Power

Press STANDBY/ON
the remote control).
The STANDBY lamp goes off.
Current source name appears.
To turn off the power (into standby mode),
press STANDBY/ON (or STANDBY/ON
remote control) again.
The STANDBY lamp lights up.
Note:
A small amount of power is consumed in standby mode. To turn off
the power completely, unplug the AC power cord.
(or STANDBY/ON AUDIO on
VOLUME
Current volume level appears.
AUDIO on the

Selecting the Source to Play

When you have connected digital source components using the
digital terminals, first change the input mode for these components
to the digital input mode (see page 11).
Press one of the source selection buttons.
Selected source name appears.
TV SOUND
DVD VCR
On the front panel
TAPE/CDR
FM/AM
On the remote
Note:
When connecting a CD recorder to the TAPE/CDR jacks, change the
source name shown on the display. For details, see page 12.
VOLUME
CD
TAPE/CDR FM/AM
SOURCE NAME
CD DVD
TV SOUND VCR
9