Table of Contents
Advertisement
Disable nouveau.
5
In this procedure, a boot image file which does not load the nouveau driver
NOTE:
is created. Please check the procedure before execution and carefully execute
it in consideration of your environment.
Use the following procedure to create a boot image file that does not load the nouveau driver.
1)
Create the following file in the following directory, describe the contents and save it.
Directory
Filename
Descriptions :
2)
Execute the following command to create a boot image file.
# dracut –-force
By executing this command, you can create a boot image file that does not load the nouveau
※
driver at boot time.
3)
Please reboot OS.
After rebooting, start the terminal and execute the following command to check that
nouveau is not loaded.
# lsmod | grep nouveau
If the X-Window System is running, exit according to step 4.
Create a Xorg.conf file.
6
Please advance towards procedure 7 when the equipment that tries to be installed is except
R120i-2M.
It creates the Xorg.conf file beforehand before installing this product when using a GUI
(graphical user interface) in RHEL 8.3 on R120i-2M.
※Please advance towards procedure 8 when there isn't using GUI.
If the X-Window System is running, exit according to step 4.
1) It executes a following command, starting up a terminal, and generates the start-up
parameter file xorg.conf of X-Window.
#Xorg –confiure
xorg.conf.new is generated in a directory login home. Please change the name of
xorg.conf.new to xorg.conf. Then, please move it to a / etc/X11 directory.
The following contents are sometimes output lastly when executing Xorg -configure but a
xorg.conf.new file is generated normally.
※After processing of Xorg.conf, please shut down the OS once and refer to the user's guide
of the equipment and install this product.
:
/etc/modprobe.d/
:
blacklist-nouveau.conf
blacklist nouveau
options nouveau modeset=0
E-16
Advertisement
Table of Contents
