Table of Contents
Advertisement
HOB - DAILY USE
WARNING!
Refer to Safety chapters.
Ignition of the hob burner
Always light the burner before you put
on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
1. Push and hold the spark generator
button
.
2. At the same time turn the knob for the
hob counterclockwise to the maximum
gas flow position
light the burner.
3. Release the spark generator button
when burner lights but keep the knob on
this position for equal or less than 10
seconds to let the thermocouple warm
up. If not, the gas supply will be
interrupted.
4. Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for more
than 15 seconds. If the burner does
not light after 15 seconds, release the
knob, turn it into the off position and try
to light the burner again after minimum
1 minute.
If after some tries the burner does not
light, check if the crown and its cap are
in the correct position.
10
and push it down to
In the absence of electricity you can
ignite the burner without an electrical
device. In this case approach the
burner with a flame, push the relevant
knob down and turn it to maximum
position. Keep the knob pushed for
equal or less than 10 seconds to let
the thermocouple warm up.
If the burner accidentally goes out,
turn the knob to the off position and try
to light the burner again after minimum
1 minute.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut.
It is normal.
Burner overview
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple
A
B
C
D
Advertisement
Table of Contents
