JVC KD-AV7010 Service Manual page 34

3.5.3 Removing the hideaway board
(See Figs.5 and 6)
• Prior to performing the following procedures, remove the top
chassis and DSP board.
(1) From the rear side of the main body, remove the four
screws E attaching the hideaway board. (See Fig.5.)
(2) From the top side of the main body, disconnect the wire
from the connector CN601
Fig.6.)
Reference:
After connecting the wire to the connector CN601, fix it
with the wire holder as before. (See Fig.6.)
(3) Remove the three screws F attaching the hideaway board.
(See Fig.6.)
(4) Take out the hideaway board from the bottom chassis as-
sembly.
1-34 (No.MA184)
on the hideaway board. (See
E
Fig.5
CN601
Wire holder
Fig.6
Hideaway board
F